Left the sun roof open overnight and when I went to get in my car the next day and close it, it wouldn't close. Looks like it is crooked and makes popping/grinding noise when trying to close. Nothing appears to be stuck in the tracks. Any e-z fix or what's it gonna cost me at the dealership?
SOURCE: Car makes grinding noise when I try to start,
You may need to install what they call shims in between the starter and the flywheel in order to align it correctly with the flywheel
SOURCE: Sholud I purchase a mitsubishi outlander 2003 with 103,291 miles on it for $8495
I have 150,000 miles, no problems. I think a front CV or bearing in in need of replacement. I have replaced the front brakes and rotors. Great on the highway.. 20MPG on the freeway..
SOURCE: 2003 mitsubishi outlander rear tires tilt in
I dont know if you have solved this yet but check the bushings on the suspension or the arms. If one is worn or damaged it will cause the tire to bend outward or inward and cause the tires to wear uneven.
Testimonial: "Thank you for the information. Will it cost much to repair this?"
SOURCE: replace front axle what tools are needed
wrenches. tire tool. hammer , pliers , a jackstand or blocks to support the vehicle. a jack to manipulate the lower control arm . air compressor and air impact wrench and a socket ( metric and usually a special size ) available at Auto zone for rent
which is refundable when you take it back ( so its free )
the sad part is that the driveshaft just pulls out of the transmission, and slips back in with a little effort. all held in place with 1 special nut. the bad part is that this PROCEDURE IS DANGEROUS because removing the lower balljoint lets the TENSION from the strut assembly FREE and can hurt you or even kill you. Please exercise caution. this task can be accomplished with minimal effort and a few tools.
Testimonial: "yes thanks"
SOURCE: 2003 Mitsubishi Outlander power window repair. I
just repair the broken wire with heatshrink[after youve respliced it] and check operation of motor.if it works,make sure wiring is securely cabletied out of the way,when reassembled
160 views
Usually answered in minutes!
×