Step by step on how to replace the front wheel bearing on 2000 mercury mountaineer
SOURCE: 1999 mercury sable front wheel bearing
Not too bad. Just remove the Wheel and the Brake Calipers. Then remove the Dust Cap off the Center of the Rotor. Inside there is a Bolt with a Cotter Pin In it. Remove the Cotter Pin and the Bolt. The Rotor will now Slide off the Spindle, The Bearings are Loose and Probably inside the Rotor. Remove these Bearings and get a Tube of High Temp Grease. Put a Big gobb of grease in the Palm of your hand and Roll the Bearing around in your Hand. Be sure to use your Fingers on the Inside of the Bearings to get it in. The same Goes with New Bearings.
SOURCE: How do I remove and replace front wheel bearing on
you need to take the tie rod off , the lower ball joint off , take the strut bolt out and remove the nut and washer off the cv axel then pull the whole hub Assembly off then the new bearing need to be pressed in , then reinstall everything not as hard as it sounds
SOURCE: diagram of front hub assembly for 1994 mercury sable.
Best solution to your problem is going ot the junk yard asking them for a left front knuckle. They will charge you about the same price for all this stuff as the auto parts store will charge you for a wheel bearing. After you have this knuckle you will be able to take a few things off of it and be able to put it on with only remvoing like 3-5 bolts.
SOURCE: 1998 Mercury Mountaineer wheel bearing
2x2 = nothing special since they are old fashion tapered bearings
4x4 = nothing special again BUT the wheel bearing is part of the hub assembly!
SOURCE: repair front wheel bearing assembly
no special tools in particular just the usual or necessary tools required.. 1stly u remove the Tyre and the caliper then u'll see something like a long rod dats the bearing
355 views
Usually answered in minutes!
×