I got mercedes benz E320 1995: Every morning My windshield wiper not working about minutes later SRS light warning lighs blink on and off right ways after that my radio turn it self on. my windshield wiper working ok. can anyone tell me what happen? alway SRS Light on and off before my windshield wiper working. thanks

SOURCE: my srs light had been on

It is my understanding that the SRS is a dealer only reset because it requires a code that is proprietory to MB dealers only. Now, a garage with a good scanner (loaded with applicable MB program) may be able to reset it for cheaper than a dealer. Nonetheless, I do not believe you can reset it on your own.

A side note, as long as the SRS light is on, your airbag and/or belt tensioners may not work if you're in a collision.

SOURCE: BAS (Brake Assist System)

need to replace brake switch intermittent problem with them ....for lights bas, abs,asr,to go off..

SOURCE: can you email me a

Hope you can make it out on the Pic

From the right to the left.
H/beam lights on
Charge Light
Brake pad low warning light
Hand brake/ brake fluid low light
Engine oil low light
Engine coolant level low
(space for outside temp display, yours might not have this)
Wind screen washer fluid low
ABS warning light (your might not have this)
Exhaust temp warning light (only if the vehicle is fitted with CAT"s)

SOURCE: srs light on dashboard on mercedes e320 1999

SRS is not DIY. I strongly suggest you go to a reputable repairer an have it scanned and unless you are very competent Auto Tech leave it to them to repair.The SRS lamp is warning you that the Supplimentry Restraint System has a fault and will NOT funtion if you have an accident. Therfore you don't have this as a backup with your seatbelts .There is a good chance that it is the pressure pad in the passengers seat as has been suggested along with loom and module failures.

SOURCE: how to reset airbag for mercedes benz c220 1994

This can not be reset by conventional methods. This must be done through a scan tool. Usually only the dealer scan tool will communicate with the SRS module. If the SRS light is on you have other issues and they must be remedied before the light will go out. There is no way of knowing what the issue is without running codes with the scan tool.