Fuse box for gmc s15 back up light
SOURCE: a/c compressor will not engage
have you tested for voltage at the compressor?
It may have a bad AC clutch, or a wire is split somewhere in the harness. check for appropriate voltage at the compressor.
you mayyy need a new compressor if you infact have voltage to it
SOURCE: WHERE IS THE FUSE BOX ON A 88 GMC S15?????
it is located on the fire wall under the dash leftup behind the eb rake
SOURCE: firing order for a 1986 gmc s15
FIRING ORDERS
To avoid confusion, ALWAYS replace spark plug wires one at a time.
The most important thing to remember about the removal and
installation of a distributor, cap or spark plug cable is that all
wires MUST be labelled before they are disconnected. Keep in mind that
these figures depict a firing order where the distributor cap terminals
are relative to EACH OTHER only and they do not necessarily depict the
tower positions in relation to the rest of the engine. This is true
because any distributor which has been removed and reinstalled may have
been installed with the No. 1 spark plug tower at any position (360
degrees) in relation to the rest of the motor, as long as the rotor
aligned to the No. 1 tower when the No. 1 cylinder was at TDC of the
compression stroke (valves closed, ready for the plug to fire). As long
as the remaining wires were connected in the correct firing order
sequence (depending on direction of distributor rotation) the engine
will run. DO NOT EVER remove more than one wire from the distributor
cap at a time unless you tag ALL wires and towers to assure proper
installation.
Fig. 1: 1.9L engine . Firing order: 1-3-4-2 . Distributor rotation: counterclockwise
Fig. 2: 2.0L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 3: 2.5L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 4: 2.8L engine . Firing order: 1-2-3-4-5-6 . Distributor rotation: clockwise
Fig. 5: 4.3L engine. Firing order: 1-6-5-4-3-2 . Distributor rotation: clockwise
I hope help you with this (remember rated this help) Good luck.
SOURCE: looking for diagram of the fuse box for a 1984 gmc
dont realy need aq digram, open fuse box check each fuse with a test lamp when you get to the one that does not vlighht up chan ge it. berrydalewolf
SOURCE: 1989 GMC S15 4X4 won't
Check the linkage . and also if you recently bough it and have neer tryed it check front driveshaft.
Testimonial: "Thanks,I'll try that"
162 views
Usually answered in minutes!
×