Hello All, I just bought a Lexus IS250 remote key fob from ebay, and would like to know if anyone has instructions on how to program it? I would really appreciate if someone can guide me on this. The key fob that I bought is: http://www.ebay.com/itm/LEXUS-SMART-KEY-keyless-REMOTE-ENTRY-CONTROL-Transmitter-FOB-HYQ14AAB-NEW-BLADE-/280878939893?pt=Motors_Car_Truck_Parts_Accessories&fits=Make%3ALexus|Model%3AIS250&hash=item4165b07ef5&vxp=mtr Please help!!! Thank you!
SOURCE: 06 mazda3 keyless remote programming instructions
It should be hit the unlock button 3 times, open and close the door 3 times, the locks will operate themselves twice. Hit the unlock button on the remote and it should program. you should try a remote from the dealer not from ebay.
SOURCE: The Lexus car remote key control model ES300
try this:
1. Start with key out of ignition, drivers door is open all others closed and
drivers door is unlocked.
2. Insert key into the ignition (DO NOT Turn) and Pull key out.
3. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Close, then open drivers door.
4. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start) then back to OFF.
D. Remove the key from the ignition.
5. Press any button on remote for a minimum of 1 second.
System should now lock and unlock doors once.
6. Close and open drivers door.
7. Press any button on remote for a minimum of 1 second. System should now lock and
unlock doors. Once to confirm programming, twice to indicate programming failed.
8. Repeat steps 5, 6 and 7 for additional remotes.
SOURCE: programing instructions for buick 2006 lacrossekeyless remote fob
Transmitter ProgrammingImportant:
All transmitters which are to be recognized by the remote control door
lock receiver (RCDLR) must be programmed in a single programming
sequence. If the system is placed in program mode it will erase all
previously programmed transmitters upon the receipt of the programming
signal from the first transmitter. Up to 4 transmitters can be
programmed. Do not operate or program the transmitters in the vicinity
of other vehicles that are in the keyless entry program mode. This
prevents the programming of the transmitters to the incorrect vehicle.
Good luck
SOURCE: trying to program remote key for 01 lexus rx300
1. original key ON 2. push gas to floor 5 times 3. push brake 6 times 4. take out key, put in NEW key DON'T TURN 5. Push gas to floor ONE TIME 6. Observe blinking security light until it stops blinking (about 1 minute) 7. DONE!
2,013 views
Usually answered in minutes!
×