Stuck in 5th gear p0795
SOURCE: 2004 nissan maxima
I have the same issue with my 2004 maxima.The service techs said it was the timing chain tensioners .Since they are hydaulic and they powered by the oil in the car .It is recommended to purge the the engine every time the noise starts to come back. I brought some an it really freaking work because I started to run it into a tree and go buy a toyota
SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA
WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....
Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...
you all enjoy your rides out htere!!!
SOURCE: Gear Shift gets stuck on Maxima 2001
The gear shift electrical relay or module inside it is not reading the signal to release. You need to have the electronic relay or module repaired or the gear shift assembly replaced.
SOURCE: nissan maxima transmission problem
my 2004 nissan maxima was doing the same thing when i took it to the nissan place they said it was the tranmisson.they was wrong i change the cam sensor the part number is css1595 and unplug the battery 5 mins.
1,556 views
Usually answered in minutes!
×