1987 Toyota Camry Logo

Related Topics:

Posted on Feb 27, 2013

1987 Toyota Camry. Idle doesn't drop. Stays very high. No clue why. Also goes through a lot of gas and found out muffler and catalytic converter aren't hooked up. Ideas of where to start?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Feb 27, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Feb 27, 2013
Answers
1
Questions
0
Helped
328
Points
3

Check your vacume hoses and if iyt has an idle controll valve that is off of the air intake. that should be the only things that would effect it

5 Related Answers

Pierre Laplante

  • 2061 Answers
  • Posted on Jul 31, 2008

SOURCE: check engine!

normally you need to change the converter if you have smog test you have no choise if not disconnect the battery for a minute and try it out hopefully it will not come back hope its a fixya thanks for the post pierre

Ad

Anonymous

  • 1861 Answers
  • Posted on Sep 16, 2008

SOURCE: 2003 toyota camry

P0420 is a cat code. Sometimes, you can replace the upstream & downstream air/fuel & O2 sensors, run some good fuel injection cleaner thru it, and that might fix the problem. If not, you may need to replace the cat. Note that the cat is covered under warranty for 8 yrs/80,000 miles. Toyota will replace it if it has gone bad, for free.

Jonah Oneal

  • 14092 Answers
  • Posted on May 24, 2009

SOURCE: 99 toyo camry shuts off while driving have to keep pumping gas until it stays running

sound like a bad fuel pump.

Anonymous

  • 986 Answers
  • Posted on Aug 30, 2009

SOURCE: 1994 Toyota Camry V6 idle is high

Your ivs is carboned up an needs replace it stuck open

Anonymous

  • 714 Answers
  • Posted on Jan 25, 2010

SOURCE: I just replaced the fuel pump on my 1987 toyota

You bet.

Also check the timing belt. If the distributor is not turing the fuel pump also will not run.

Hope this tip helps.

R/
David

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Is the Cadillacic converter stopped up on 1998 Toyota Camry 4 cylinder

Hello Rodney, If you notice a lack of flow from you tail pipe when you increase the engines RPM or a lack of power when stepping on the gas while driving you may have a plugged catalytic converter, muffler or a obstruction in a exhaust pipe. If you have any doubts after checking the above, get it into a shop to be tested...plugged exhaust systems can cause excessive heat build up and damage your engines exhaust valves.
1helpful
1answer

6cyl,1994 toyota camry shuts off when shifted, but when car stays on it doesn't go with full power and over heats an shuts off. takes a couple of startups to get to stay one when its cold it shift

your catalytic converter may be clogged, if it is bolted on loosen the bolts and pry it away then try to start. if the power returns then you need to replace the catalytic converter. also is it an automatic or standard transmission? If automatic the torque converter is stalling at to low of rpm and needs to be replaced.
0helpful
1answer

I have a 2008 mercury Milan with nearly 60k miles on it. When I come to a stop the rpm drops by 1000 then recovers quickly. What should I do to fix the problem? Any suggestions will be greatly appreciated.

Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode? http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces? http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increases http://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000? http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills? http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPM http://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM? http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

0helpful
1answer

Driving on the road the RPM goes higher wituout speedind

Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

0helpful
1answer

My 1991 Chevy s-10 rear wheel drive 4 cylinder has had problems staying on. Every time i turn it on i have to press the gas pedal all the way down for it to stay on and even though it stays on for a bit it...

That year S-10 had a lot of caburator problems and vaccum leaks . Check vaccum leak's first then Check you ilde control curcuit inside the caburator the idle jets may be clogged you also have a idle control set screw that can be adjusted to set the idle higher.
5helpful
2answers

Loud muffler noise up front of vehical.what is

If the noise sounds like your muffler, but isn't coming from the area of your muffler, then you have an exhaust leak upstream from the muffler.

From the front of your muffler, follow the tubing forward to the catalytic converter, then forward to the engine exhaust manifold.

If you start with the car sitting for a few hours to make sure it's cold, you can use your hand to feel for blowing leaks while the engine is running, but chances are you'll be able to hear it. be careful of the catalytic converter itself, as it heats up fast, so check that first.

Once you've found the leak, the fix depends on the emissions laws in your state. If you have none, and the leak is in the middle of the pipe, you can buy pipe patchers (metal preferred) through auto parts stores or catalogs/websites. If you have strict emissions laws, or the leak is at the junction of the catalytic converter and pipe, you'll need to replace the failing part.
1helpful
1answer

97 Camry Rough cold idle, weak accelleration and noisy exhaust

Lots of times the idle air control valve gets stuck on these engines. You can try cleaning it. Remove the air intake hose from the throttle body. Start the engine and spray throttle plate cleaner through the hole in the bottom on the throttle body. This will run the cleaner through the idle air control valve. make sure to keep the RPM's at about 2000 to 2500 throughout this procedure. You may need to install a new idle air control valve if it continues to happen.
1helpful
2answers

Catalytic Converter Problem

i have a 1990 toyota camry, it is overheated very fast, its catalytic converter is clogged and i drilled a few holes in it to let some of that stuff out to let it generate right, but it is not wanting to stay crankedand when the engine gets to a certain temperature, the sound of the engine changes and if you hit the gas all it does is shake and you hear a pinging sound in the engine and when you cut it off it wont crank again until it cools all the way back down
Not finding what you are looking for?

338 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...