Question about 2001 Toyota Echo

1 Answer

Where is charcoal vapor cannister on 2001 toyota echo

Check engine light on,,,,code p440

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Toyota Expert
  • 276 Answers

Under the rear of the vehicle under the trunk

Posted on Mar 10, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 67 Answers

SOURCE: toyota echo engine light

these are evaperative emmisions code 440 is a general evap malf 446 is a small leak code. sometimes these codes are set after fueling, if the fuel cap is not correctly installed. or if the fuel cap has been lost and replaced with one that does not seal well.

Posted on Dec 08, 2008

  • 218 Answers

SOURCE: 2001 toyota echo engine light is on. Car idle is rough and sometimes stalls. Is there a way to clean the idle air control valve without removing it?

NO U HAVE TO REMOVE THE IAC TO CLEAN.DO U KNOW WHET CODE THE LIGHT IS SETTING?

Posted on May 05, 2009

MNfisherman
  • 11896 Answers

SOURCE: I'm getting the check engine light code: P0171

Trouble Code: P0171

Fuel System Too Lean (Bank 1)
Possible Causes:


A/FS or HO2S is contaminated, deteriorated or it has failed Air leaks after the MAF sensor, or in the EGR or PCV system Base engine "mechanical" fault affecting one or more cylinders Exhaust leaks located in front of the A/FS or HO2S location Fuel system supplying too little fuel during cruise or idle (faulty fuel pump or fuel filter) Fuel injector (one or more) dirty or pressure regulator has failed Vehicle driven low on fuel or until it ran out of fuel

Posted on Jul 23, 2009

techbuster
  • 5081 Answers

SOURCE: please where is the charcoal canister on toyota

It is located in the rear of the vehicle, underneath. It's above the rear suspention components, between the gas tank and the depression in the trunk designed for the spare tire.

Posted on Sep 25, 2009

  • 133 Answers

SOURCE: I have a 2000 Toyota Echo with a P0440 code on the

Clean the air flow meter with carb cleaner spray and that should do the trick'

Posted on Mar 08, 2010

Testimonial: "Thank you, I will try it this weekend. For how long I"ve been fighting with this, if it works, I could kiss you :) "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Check Engine Light. I have p420 P440 and P446 codes


You need a Catalytic converter and possibly a Evap. cannister

Oct 04, 2014 | 2003 Toyota Corolla

1 Answer

The check engine light is on. the scan reads 441 and 445


1st. Make sure your fuel filler cap is tight, clean, and sealed well.
These are codes set when there is a fuel vapor leak.

P0441 EVAP Control System Improper Purge Flow.
P0446 EVAP Control System Vent Control.

This indicated a problem with the evap emission control system. This is the part of the emission controls that captures gas vapors in the tank, stores them temporarily in a charcoal canister, and then burns them by "purging" the charcoal canister into the intake.

Could be something as simple as a loose or faulty gas cap. Can also be vacuum lines for the purge valve and canister or a bad purge valve itself.

This code is infamous code, its a bit complicated if not mechanical incline, I would recommend finding an of duty Toyota mechanic to do a side job. There are plenty of those guys will do side work and will save you big bucks, however you will have to asked around when you get the next oil change. any repair manual will have proper instructions. same time, purge valve is either bad or clogged. i'd, also, clean EGR valve.

the cannister is mounted in the rear underside of car above the rear crossmember,you either have to remove the exhaust or lower the rear crossmember to gain access to the charcoal cannister.. there is also a vsv valve that mounts on the air cleaner housing.
these would be the 2 common items that can set these codes although there can be other issues that can set the codes you have
most of the testing is done with a scan tool . and vacuum pump there are a few test to do with a voltmeter.
http://youtu.be/FQFULrEY3NE

Nov 22, 2011 | 2005 Toyota Corolla

1 Answer

What causes the check engine light to come on in a toyota echo 2004


take it to autozone and have the fault codes read for free
the charcoal cannister that they speak of is the EVAP cannister and if there is a problem with it it will show as a fault code
it has a purge valve and a purge valve solenoid for operation , both of which can be replaced separately
when you hear" I think " , time to find an accredited service center that has experience on your make pf vehicle and get a second opinion
the gas tank neck is a rubber section and comes up in the code as a small leak
a simple loose gas cap will put the light on

Mar 26, 2017 | Cars & Trucks

1 Answer

2005 Toyota Echo. front end noise (rattling/rumbling) when I am stopped at a light.


I had this on my 2002 Yaris, with 103,000 miles on the clock. I found that the rear engine mounting rubber bush was partly torn and the charcoal cannister was loose (not inserted in bracket properly). I installed a used rear engine mount off e-bay, straightened the cannister bracket and inserted it properly. Knocking noise at low revs now sorted.

Jan 14, 2011 | 2002 Toyota ECHO

1 Answer

My name Tommy V, I have a 2001 Toyota Echo, the CK engine light was on, went to a car parts store used their code reader, code was PO441 Evaporative emission control -System incorrect, purge flow. I used...


The EVAP cannister is part of the emissions system. Excess exhaust runs thru it-purge flow is when it is released. Check all the vacuum lines going to it. I don't you will find a parts listing for a purge flow valve or vent or solenoid. Your light will probably come on again shortly.

Mar 15, 2010 | 2001 Toyota Echo

1 Answer

Evaporative system


The system consists of a charcoal cannister that collects gas vapors from the fuel tank. It stores these vapors until certain engine conditions are met, and then a purge valve/solenoid opens and the vapors are used in the combustion process. A faulty gas cap will cause the problem if it is not sealing or venting properly. A bad purge solenoid could also not be allowing the cannister to purge and the cannister could be full.

That's a basic synopsis. Hope this helped and best wishes.

Jul 25, 2009 | 2001 BMW 5 Series

2 Answers

Emission Control Systems Malfunction


Check the gas cap! However, if you need more ...
We have pictures and our experiences with these codes and how to tell if it's the canister, the valves or the cap.

http://www.findonefindall.com/toyota-sienna/toyota_sienna_evap_P0446.htm

May 23, 2009 | 1997 Toyota T100

2 Answers

Check engine light is on...


I am not going to lie, I came across this in another forum a while back and I would love to retype it and interpret it here but it is too much. I looked at it and verified that the information here is information that could be found through my scan tools so here it is!

P0440
The fuel tankmag-glass_10x10.gif pressure is atmospheric pressure after the vehicle is driven for 20 min (2 trip detection logic).

Possible Problems
Fuel tank cap incorrectly installed <= Most common
Fuel tank cap cracked or damaged (Toyota part only)
Bad vapor pressure sensor/circuit
Vacuum hose cracked, holed, blocked, damaged or disconnected 
Hose or tube cracked, holed, damaged, or loose
Fuel tank/filler neck cracked, holed, or damaged
Charcoal canister cracked, holed, or damaged (collision)

In above description, check hoses between vapor pressur sensor and VSV for vapor pressure sensor and charcoal canister. Also, hose between charcoal canister and fuel tank.


Mar 11, 2009 | 2002 Toyota Camry

2 Answers

Toyota T100 OBDII Code P0450 - Pressure Sensor Malfunction


P0450 deals with the Vapor Pressure Sensor, in the fuel tank vapor circuit. Buying a charcoal canister would not cure this.
Go to a Toyota dealer and tell the parts guy that you want a
Vapor Pressure Sensor.
It is on the vapor line, before the charcoal canister.

After you replace the sensor, remove the EFI fuse to clear the code.

I hope that this answers your question.

Please rate my assistance level with a FixYa rating
(4 blue diamonds)
Thanks!

Feb 10, 2009 | 1997 Toyota T100

Not finding what you are looking for?
2001 Toyota Echo Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...