My remote trunk button works but the interior trunk button doesn't any more. Is there a fuse for it? Where would that be? All my fuses look good and I don't see anything labeled for trunk.

how do I reset one of two keys that the unlock,lock,trunck does't work but the key turns the engine over.

There is a fuse box under the right rear seat cushion behind the driver. In that box is a 10 amp mini fuse marked "TRUNK DR RELEASE". That is the fuse that powers your remote receiver. If that fuse is good, the receiver may have failed. To remove the seat cushion, pull the front of the cushion up and then forward.

There are 3 phases to fixing your car's trunk lid release problem.

Phase 1: First check the fuse - once you know that's OK, then proceed to phase 2 (below).
The fuse for the trunk lock is
the bcm (pwr) 15A fuse in the instrument panel fuse box (behind panel at drivers right foot)

Check that fuse, as it is the power supply for the button on the dash that sends power to the actuator in the trunk.

Phase 2: Get the trunk open (without taking it to the dealership).
If you have remote keyless entry to the trunk, you could try that - but with the actuator
dead/dying, it shouldn't work.

Here are a couple of ideas to try to enter trunk while (a) actuator isn't working, and (b) all
valet lockout features (designed to deny valets access to the trunk) are in the "Lock" position:

There is the lock cylinder, which you stated is not functioning - put the key in, and it doesn't
turn. Just to be sure, consider: lubricate key with Graphite lock-type lubricant, and retry.

The trunk has 2 valet safetys...the locking rear seats which require access to the trunk to unlock, and then there is a valet switch in the trunk that locks the button on the dash from working to keep valet parking attendants out of the trunk. That may be in the lock position.

You can try accessing the center area of the fold down rear seat and see if you can unhinge the rear seat from there. Maybe reach in with your hand, or an extension-type tool.

there may be a way to fold the hinge away from the seat back so it can be removed from the hinge and give you access to the safety latch in the trunk and open it that way (white handle in trunk).
The white-handled safety latch release is desiged to prevent accidentally trapping children, and
if you can pull it with your extending-type or grasping-type tool, the trunk will open whether or
not the actuator motor is working.

Phase 3: Replace the Problem part.

Your failed part may be either (1) Trunk Release Relay, or (2) Trunk Lock Release Switch

My Satrun ION manual doesn't cover either of these parts, and the online parts houses, e.g.
http://www.rockauto.com/catalog/x,carcode,1431624,pgname,Electrical-Switch%2B%2526%252338%253B%2BRelay,a,search.yahoo.com%2BSearch%2Bfor%2B2004%2BSATURN
fail to provide instructions. One of those times a mechanic has to t=rely on his/her native
handiness and/or experience.
To identify which of these parts is bad, locae the Trunk Release Relay (call your dealer parts
dept. for helpful tips on finding it), then operate the dashboard trunk release button with your
ear close tothe relay - if it makes a noise, the problem is the Trunk Lock Release Switch in
the trunk lid, otherwise its the relay.

Hi
check the fuse box for fused fuse and replace them with the corresponding fuses.
Regards.

Make sure the valet lock on the underside of the trunk is not switched.

I would start by checking the fuses..The fuse panel is on driver side end of dash/ pull to remove.If you have the owners manual look under (fuses) tail/brake lights..If you find a blown fuse replace with same...

Hi, you can jump the car at the engine. Just hook the negative jumper to a good engine ground point and hook the positive to a big hot point, like the starter solenoid. An easier spot would be a fuse box terminal if there is one handy.
If you just want to open the trunk and jump start from there, you can make your remote work by jumping to the interior fuse box. Hook the negative jumper to a good chassis ground point, turn the key on, hook a wire to the positive jumper and touch it to most any point in the fuse box while clicking your trunk button.
Let me know if you have questions and thanks for using FixYa.

remove the switch if conected it may be bad, wen doing audio intallation or electricall maybe lef it disconected

There is most likely a fault in the system and it will have to be reapired by certified tech

Hi,

To open the trunk, you could try:
1. using the key, push down on the back of the trunk while turning the key. A word of caution and try not to force otherwise, the key might be twisted cut;
2. use the automatic trunk opener (in the glove compartment). You would need someone to press down on button while another is pushing down on the back of the trunk;
3. alternately, there are some models where the rear seats fold down and opens into the trunk.

On the fuse/interior lights and locks, if you have replaced with a known good fuse and problem persist, it may be caused by:
a. corroded or loose fuse holder;
b. corroded or loose fuse block connector;
c. corroded or loose harness connector (unfortunately inside the trunk);
d. defective wiring harness;
e. loose ground.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.