Rear door passenger side door wont open both handles are loose how door i get the door open to take the cover panel off
Get a tool from the parts store called a slimjim.. its a thin long metal bar that has notches in one end..it will fit between the weather strip and the windowglass and allow you to "trip" the door latch to open the car door(just like car thieves do!) and then you can acess the door panel to fix those pesky handles..
SOURCE: passenger door on 98 sonata wont open
dear friend-this is a tricky one but it works,roll the window down.remove the outside strip.push the widow aside and look inside for the door lock,take a piece of wire and make a hook on one,use the hook to unlock vehicle.
SOURCE: I need to replace the
Welcome to FIxYa.com Image -1 Rear Door COMPONENTS REMOVAL AND INSTALLATION Image-2 1 Remove clip using a piece of cloth (Manual type only).Then
the door window regulator handle. Image-3 2. Remove the rear door inside handle housing. Image-4 3. Remove the mounting screws (3EA) from the rear door trim
panel. Image-5 4. Insert a trim panel remover between the trim fasteners
and the door trim panel to pry off. Disconnect the connector. Image -6 5. Remove the door pull handle mounting bracket and door
inside handle. Image 7 6. Remove the door trim seal. Image-8 7. Down the door glass and remove the door glass run and
delta lower channel. Tightening torque Rear door glass mounting bolts: 0.8- 1.2 kg.m (5.8- 8.7
Lb.ft) Delta lower channel mounting bolts: 0.8- 1.2 kg.m (5.8-8.7
lb.ft) Image-9 S. Remove the carrier plate mounting bolts from the door
regulator channel and remove the door glass. Image-10 9. Remove the door regulator channel mounting bolts and then
remove the door regulator assembly. Tightening torque Door regulator channel mounting bolts: 0.4 -0.6 kg.m (23 -
4.4 lb.ft) Image-11 10. Loosen the door lock actuator mounting bolts and remove
the latch assembly. Image-12 11. Remove the door outside handle mounting bolts. Image -13 12. Remove the waistline molding. 13. Installation is the reverse of removal. When installing the door trim seal, butyl tape should not be
placed over door trim fastener mounting area. images coming up next Thank you for using FixYa.com Regards, Lee Davidian
1,549 views
Usually answered in minutes!
×