1995 volvo 940 the car keeps hesitating and wont go past 55 does anyone now whats wrong

SOURCE: 1993 Volvo 940 gle - speedometer not working

about 240.00 according to the volvo dr. ,fountain vally ,ca. An elect. part behind the speedo. is the problem . My 91 940 speedo stops working at 45 mph. thats what they told me. good luck,pete.

SOURCE: 95 volvo 940 DL hesitates injector error codes 113, 212, 232

Check the fuse to the injector. If it is out or got wet, it could mimic these conditions. let me know what happens. I have an 85 model.

SOURCE: 1991 Volvo 940 SRS light wont go out

You have an problem with your airbag system,Whats way your SRS is on the ,only way to find what is the problems,in the airbag system

SOURCE: 1994 Volvo 940 turbo wont start!!!!!! =[

I am a volvo tech and your problem is fuel pressure ralated and i had same problem in 1995 850 turbo and the fuel pump was the problem and a used one is around 35.00

mx5turbo92

• 545 Answers
• Posted on Jun 04, 2009

SOURCE: I need to replace the fuel pump in my 940 Volvo.

Disconnect battery ground strap before beginning to work on the fuel/electrical system. Do not smoke or have anything in the area which can ignite or cause sparks

1. Drain enough fuel from tank to prevent spilling, no more than 4 gallons (16 liters) of fuel should remain. Use suitable pumping equipment.
2. Remove floor mat and panel from trunk.

1. Disconnect wiring harness connector to sending unit. Remove wires from connector.
2. Disconnect ground wire to sender. Push wires through grommet.
3. Remove cover for access to tank sending unit.

1. All models: Disconnect from the fuel tank sending unit:

1. Breather hose C
2. Return hose A
3. Supply hose B
4. Filler hose D
5. Wiring harness from clip E

1. Clean area and unscrew fuel tank sender/pump cap or equivalent. Remove tank sender/pump and seal.
2. Remove pump from sender/pump assembly.

1. Inspect the pump for damage, feed pump hose and wiring for wear. Replace as needed.
2. Install new pump to sender/pump assembly.
3. Install rubber seal in neck of tank. Lubricate inside of seal.

1. Install fuel tank sender/pump unit. Align it with the moulded joint (arrows) on tank.
2. Apply rustproofing compound to exposed metal portions of tank sender.

1. Torque fuel tank sender/pump lock ring to: 22 ft-lb (30 Nm)
2. Reassemble components in reverse order. Use tie straps to secure all hoses and wiring.