Question about 1995 Jeep Grand Cherokee

1 Answer

1995 grand cherokee, 318 eng. cranks won't start. jeep dealership pulled the security module, still does same thing. before, i had to turn key on and wait for 5-10 minutes and it would finally sta

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

Replace your idle air control valve located back of the throttle body.

Posted on Feb 24, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: 1995 Jeep Grand Cherokee Orvis 5.2L V8 will crank but not start.

Fuel delivery is influenced by engine temperature sensor. (sometimes a seperate unit from gauge sensor). Since you did not mention any performance problems after starting or on hot re-starts, that's where I'd look first!

Posted on Dec 11, 2008

  • 718 Answers

SOURCE: 1995 Grand Jeep Cherokee

The lower speeds are controlled by a resistor block. That's what needs to be replace. It's usually located next to the blower. It will have electrical wires connected to it. High speed bypasses the block so it alway works.
If you want to replace it then;
) Disconnect the battery negative terminal if the vehicle have air bags. Wait 2 minutes for system to discharge.
) Remove the kick block on the passenger side. )Remve the glove box ) Remove the bolts holding the blower motor resistor. Push the red lock up and press down on the click ) Pull the block out. ) Install new block and reverse steps above.

Posted on Apr 14, 2009

  • 6982 Answers

SOURCE: my 1996 jeep grand cherokee doesnt start half the time

Sounds like a poor connection somewhere...Best time to check is when it's in no-start condition...When running, obviously whatever isn't working is (temporarily). Once you identify the system (fuel, spark etc) that's not working, check all wires and connectors for good contact and continuity.

Posted on Jun 26, 2009

  • 1 Answer

SOURCE: security light flashing wont let you start jeep

the alarm seems to be activated. press the button and turn the key.

Posted on Sep 11, 2009

  • 1 Answer

SOURCE: electronic key on 2008 jeep

electronic key on 2008 jeep cherokee says key damaged or key not programmed. car won't start. some things work but radio won't come on. etc..

Posted on Aug 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1995 jeep grand cherokee cranks but won't start


I have a 1995 Jeep sport it crank but wont start I dont know what it could be

Jul 01, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Our 2007 Jeep Grand Cherokee randomly won't start.


change the wires that go to the starter i had the same problem fixed now with no problems

Jun 20, 2012 | 2005 Jeep Grand Cherokee

1 Answer

1993 dodge Grand Cherokee with a 318 hard starting when cold until things under hood click and fuel pump runs.


Your jeep ecu is in need of repair. It has what is referred to as the delayed check engine light problem. If you'll notice, next time you try starting the jeep, it will not start when the check engine light finally comes on, on the dash. The fuel pump will only come on when the ecu finally energizes the relays, and that's when all the clicking starts. Look on ebay for an ecu repair service.

Nov 29, 2011 | 1993 Jeep Grand Cherokee

1 Answer

Cherokee won't start it cranks but won't start and security light comes on


i dont know if this helps, but i know in some models, the security issue is caused by the key itself. if there is an rfid chip in the key and it is not responding to the computer, the motor will not start. try using your VIN to get a new key made at a dealership.

Oct 06, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Electronic key on 2008 jeep cherokee says key damaged or key not programmed. car won't start. some things work but radio won't come on. etc..


electronic key on 2008 jeep cherokee says key damaged or key not programmed. car won't start. some things work but radio won't come on. etc..

Jul 24, 2011 | 2008 Jeep Cherokee Grand

1 Answer

I can't start my 2008 Jeep Grand Cherokee with either key fob. Once I got a "Service Security Key" message. Another time I got the "Key not programmed - Damaged key" message. What...


Hi Hal,

Did you ever get this resolved? Looks like you didn't get any feedback here! I'm having the same issue sporadically. I turn the key and nothing. Usually if I keep trying it will eventually start cranking and start. Usually within 10 - 15 tries. happened last night. After it started, I got the "Service Security Key" message. I looked in the manual and it does say what that means. Don't know if it is programming (probably not because the fob works 97% of teh time) or maybe just a dying battery. If you can share anything you might have founf out I'd appreciate it! thanks!
Brian

Jul 04, 2011 | 2008 Jeep Cherokee Grand

2 Answers

My 1998 jeep cheorkee engine turns but won't crank, could it be the computer or what?


it's highly unlikely, there are only two things that can make this happen, not getting fuel (fuel pump failure, fuel pump regulator) or not getting ignition (bad coils, ignition module failure, bad distributor, distributor cap, rotor)

Jun 24, 2011 | 1998 Jeep Cherokee

1 Answer

1995 Jeep Grand Cherokee Sport it just won't start. It cranks, that's it. It was running fine yesterday.


If it was running yesterday and only cranks this morning you need to determine which you are missing - spark or fuel. The spark is easy - pull a plug and let it spark to the frame. while cranking. If you have spark then you have to start checking the fuel system.

Jun 23, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Replaced Fuel pump module now 1995 Jeep Grand Cherokee 4x4 will turn over but will not start. Acts like security system is engaged but have gone thru the steps to disengage and still will not start. Can...


Does it have spark while cranking the engine? Will it start while cranking and spraying starting fluid/carb cleaner into intake? If it still does not start with the spray fluid, check your crank sensor.

Oct 22, 2010 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...