WILL THE STARTER OF A 2005 SENTRA 1.8 NEED TO BE ADJUSTED AFTER MOTOR MOUNTS BEEN REPLACED

https://www.google.com/search?q=2005+nissan+sentra+1.8+starter+relay

and

https://fuse-box.info/nissan/nissan-sentra-b15-2000-2006-fuses-and-relays

..

check your motor mounts, see if your exhaust is loose or too near something.

1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Note: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
4. Remove two mounting bolts (2).
5. Move starter motor towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor (1) during this process, do not let starter motor hang from wire harness.
6. Tilt nose downwards and lower starter motor far enough to access and remove nut that secures battery positive cable wire harness connector eyelet to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
7. Remove battery positive cable wire harness connector eyelet from solenoid battery terminal stud.
8. Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle.
9. Remove starter motor.

disconnect the battery, jack it up and take it out

you have just two actual motor mounts driverside and passengerside

If you have a standard shift transmission.....give it a push with the key on and release the clutch in 2nd gear to start it.
An automatic will have to be towed.

You need to loosen the motor mount slightly--just a full turn or two. Place a jack under the oil pan and lift the engine until the strain is relieved on the motor mount and finish removal. Replacement installation is the opposite except you'll want to tighten the new motor mount into place fully (if possible) before lowering the jack.

first of all you don't have to loosen the pulley,this will no solve the problem,well you already loosen the adjuster,good,bot thing you have not done i will tell you now,on the power steering pump where the belt pass there is also a bolt that hold it ,you must loosen that also,then after you will see the pump moving on the two position that means you will see the belt loosen on 1 position an d the position it will tight the belt,try that man.............

1. Remove or disconnect the following:
   
   Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
Install or connect the following:

Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable




Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.