Chevy venture van shifting forward but not reverse

SOURCE: Thermostat in a 2003 chevy venture van

the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

SOURCE: rear brakes scrubbing on 1998 chevy venture van

Removal Procedure Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from being pinched between spring and shoe web or spring and backing plate.

1. Remove the brake drum. Refer to Brake Drum Replacement



Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.

2. Use the J 38400 in order remove the adjuster spring (1). Disengage the adjuster spring loop from the tab on the adjuster actuator.
2.1. Remove the loop end of the adjuster spring from the adjuster actuator. 2.2. Remove the straight end of the adjuster spring from the secondary brake shoe.



3. Use the J 38400 in order to spread the brake shoes apart.
4. Remove the adjuster.

1. Use the J 38400 in order to spread the brake shoes apart.



Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the park brake actuator (3), and the adjuster actuator (1) properly.

2. Install the adjuster.



Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.

3. Install the adjuster spring (1).
3.1. Install the straight end of the adjuster spring into the secondary brake shoe. 3.2. Install the loop end of the adjuster spring to the adjuster actuator.
4. Install the brake drum.

SOURCE: my chevy venture 2001

Is the fluid full ? is the fluid clean compared to new fluid ? if you answered no to both of these questions you may need a transmission

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....