When the car gets hot after a short distance the gears will not change and sometimes cease up
1 make shore you have the correct grade AUTO transmission oil.2 fit an external oil cooler. This can be done two ways. no1 add it into the system by cutting the oil return hose from radiator to the gear box and install the cooler or. no2 completely disconnect the radiator and install the external cooler independently.either way you will need oil cooler 2 lengths of transmission hose & 4 hose clamps. In Australia it comes as a kit with all clamps & hoses cost depends on size small medium or large cooler. when fitting I found it best to cut the pipes in the space between the radiator & the motor gives you more room to work just have to use longer bits of hose. Hope this helps. sick51
SOURCE: My 1997 Kia Sportage engine is rattling.
hi dear, kia sportage 1997, when drive a car between 60 to 80k/m grear is not shift 3rd to 4th, some time work some not work & rpm going up & down. please tell me what need to do. thanks ([email protected])
SOURCE: Change Belts on 1997 Kia Sportage
first loosen your altenator and take that belt off over the fan then the skid plate off the bottom and there is a tensioner pulley there for your a/c belt then your p/s belt loosens from the power steering pump pulley just turn the bolt counter clockwise and itll come off thats how my 99 works
SOURCE: Hav Kia Sportage 1997. Alarm system not working
The alarm system is under the console,it can be crossed out on the right wires.
SOURCE: timing belt diagram 1997 kia sportage 4x4
My scanner isnt working, so i hope this can help you out some...On the left Camshaft..you will a stamp I and E...iI is for intake and E is for exhaust..The I should be up at 12 o'clock and the E should be at 4..you will also have marks on the timing plate behind the camshafts to help you line it up right...Now on the Right Camshaft you will have the same marks, but this time you want the E at 12 and the I at 7 o'clock..And the crankshaft should have a little notch on it, where you can line that up at 12 o'clock with the notch imprint that is on the plate for you..You may have to clean those areas, and use a light, so you can see them..I hope this helps you out..Goodluck...
SOURCE: auto transmission hold light flashes and wont
well what i would do first is smell the transmission fluid if it smell burnt the transmission must come out,if not drop the valve body and check for a stuck valve or a check ball stuck in the separator plate try that over and out joe cool
115 views
Usually answered in minutes!
thanks michael but my car is a 5 speed manual 4x4, I should hav stated that so sorry.I have just gotten the car out of the machenics and replaced the bushes/ selectors i think and said that maybe the linkages need replacing. Does this make sense. Any input would be greatly appriciated. thankyou.
×