SOURCE: Repost RE: 2009 Hyundai Acent Airbags
yes that would work. and the system is not disabled its just letting you know you have a problem
SOURCE: Repost RE: 2009 Hyundai Acent Airbags
probably not the seat is like a sensor it knows what the weight should be
SOURCE: 2008 MKz - Remove Objects Near Pass Seat
Do you have anything under the drivers seat? Fords will put the airbag module under the seat, if anything is packed around it, it can cause the airbag light to come on. Remove any items around it and check the connectors are firmly in place.
SOURCE: I replaced my driver seat
FIRST OF ALL, DID YOU REPLACE THE AIR BAG AFTER DEPLOYEMENT ? IF SO, YOU HAVE TO REPLACE THE MODULE.
LOOK UNDER THE CONSOLE IN FRONT FOR THE MODULE.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
69 views
Usually answered in minutes!
×