I replaced the ignition controll module and it still backfires and will not start
SOURCE: 92 astro 4.3 stalls backfires hesitates
i put a new distrubter in and set the timing it saiad top dead was no4.but it still backfires
92 cheve blazer vortec v-6
SOURCE: chevy cavalier
try to replace the TPS or the IAC. It just might not be getting enough fuel or it is getting too much fuel.
SOURCE: 1997 chevy astro van
The control module is located just behind the ignition coil. Sorta hard to get to but we got it and the van is running great.
SOURCE: 2000 Silverado-4.3 ltre-cranks over-wont start-consistenly
Yes. First, in the fuse block under the hood check INJ A fuse and INJ B fuse. INJ A fuse is circuit 1039 which feeds the coil. If the fuse is OK, replace the coil electrical connector. I stock 2 of these at my dealership because they are needed quite often.
FYI P1351 is an ignition coil control circuit DTC.
SOURCE: 98 chevy malibu wont start when cold outside.
if you are mostly having trouble with cold weather,i would check the engine temp sensor,it tells the computer how cold your engine is so in the morning the computer will increase fuel like an old carb with a choke
842 views
Usually answered in minutes!
×