2005 toyota corolla airbag light problem

A fault in the system could be a sensor have vehicle scanned for codes

list of airbag flash codes.

12=Low Battery Voltage
13=Air Bag Circuit Shorted to Ground
14=Primary Crash Sensor Circuit Shorted to Ground
21=Safing Sensor Not Mounted to Vehicle Properly
22=Safing Sensor Output Shorted to Battery Voltage
23=Safing Sensor Circuit Input Feed/Return Circuit Open
24=Safing Sensor Output Feed/Return Circuit Open
32 Driver Side Air Bag Circuit High Resistance or Open
33 Passenger Side Air Bag Circuit High Resistance or Open
34=Driver Side Air Bag Circuit Low Resistance or Shorted
35=Passenger Side Air Bag Circuit Low Resistance or Shorted
41=RH Primary Crash Sensor Feed/Return Circuit Open
42=LH Primary Crash Sensor Feed/Return Circuit Open
44=RH Primary Crash Sensor Not Mounted to Vehicle Properly
45=LH Primary Crash Sensor Not Mounted to Vehicle Properly
51=Air Bag Diagnostic Monitor Internal Thermal FuseFuse Blown Due to Intermittent Short to Ground
52=Backup Power SupplyVoltage Boost Fault
53=Primary Crash Sensor Circuits Resistance to Ground or Air Bag Diagnostic Fault

air bags
get the bags scanned,
read the FSM on bags yet< (factory service manual)
or at alldata.com, DIY.
in what country? , did you read the TSB recall yet>?????
huge recall.
where is this 31 code? at>?
Trouble Code: B1000/31 (1.8L L4 VIN R Auto)
Airbag ECU Malfunction * Airbag sensor assy center

remove battery neg lug before touching any SRS parts.
B1000/31; Center Airbag Sensor Assembly Malfunction (2006 Corolla From 07/2005) DESCRIPTION The center airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the center airbag sensor assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1000/31 is recorded when a malfunction is detected in the center airbag sensor assembly.

If only DTC B1000/31 is output, do not clear the DTCs, replace the center airbag sensor assembly.
If any DTCs other than DTC B1000/31 are also output, troubleshoot those DTCs first.


use a real scan tool
and see all errors.
if not you guess wrong.

Has the car been in an accident and the airbag been deployed?

You'll need to have someone check the system for trouble codes to proceed with testing. It could be a sensor or the control module.

Hey

"Best deal with your choice".Please visit the site

Hello, you can download it here but please do registering first :
www.toyota.com/owners/apps/manuals.do?siteid=too_toyota_manuals

Best regards, Jay

the buzzer is coming on because the lights are still on. the car is warning you of this. lights staying on may be a bad sensor or bad light switch.

Air bag sensor got knocked loose and either needs to be replaced or needs to be re mounted. You may have to take it to a dealership to get them to figure out which one has gone