I've recently bought a new bumper for a '99 Honda CR-V and have removed 8-10 screw-washer combo's and a couple of hex-type bolts from the old bumper. I also tried to unscrew the center piece (right above the nose of the bumper) that sits between the lights and the bumper still won't budge after removing a couple of screws in that as well. Can anyone give me some hints on how to remove the bumper? Thanks!
SOURCE: How to change the whole headlight assembly on a 05 Honda CRV
When you raise the hood, look for a Phillips screw that holds the parking lamp in. if it is there remove screw and pull parking lamp toward front of vehicle. If headlamp and side lamp are 1 piece, there should be 2 number 10 mm headed bolts that are vertical, that hold the assembly in. The side lamp will have a stud that holds the light to the fender. You may have to pry it loose. Reverse procedure to install.
SOURCE: removing rear light assembly on honda odyssey 2006
Yes, there is a "spear point" plastic clip that is still engaged into a socket type holder in the front outboard portion of the tail lamp assembly. Pry gently with a tape wrapped screwdriver at the front outboard corner of the assembly and the clip will release. You will then be able to see how the clip works and will be able to align and engage it first when replacing the tail lamp assembly.
-T
SOURCE: How do I remove the radio from a 1998 Honda CR-V?
UNSNAP PUSH-PIN FASTENERS FROM BOTTOM OF CENTER CONSOLE
AND REMOVE BOTTOM PANEL.
2. EXTRACT 4 SCREWS FROM BOTTOM EDGE OF BEZEL. EXTRACT 4
SCREWS FORM INSIDE DASH BELOW POCKET. PULL CUP HOLDER/
POCKET ASSEMBLY OUT OF DASH AND REMOVE.
3. OPEN GLOVE BOX AND REMOVE STOPPERS. EXTRACT 2 SCREWS
FROM RIGHT SIDE OF CENTER DASH BEZEL..
4. FROM BELOW STEERING WHEEL EXTRACT 2 SCREWS FROM BOTTOM
EDGE OR PANEL, UNSNAP UPPER EDGE OF PANEL, UNPLUG, AND
REMOVE.
5. UNSNAP TOP EDGE OR CENTER LOWER BEZEL, UNPLUG, AND REMOVE.
6. EXTRACT 2 SCREWS FROM SIDES OF POCKET.
7. UNSNAP RADIO/AC CONTROL DASH BEZEL, UNPLUG, AND REMOVE.
8. EXTRACT 2 SCREWS FROM EACH SIDE OF THE RADIO BRACKET
ASSEMBLY TO REMOVE RADIO FROM DASH/AC BEZEL.
SOURCE: 2005 odyssey tail light bulb replacement,how to do
There is a little connector to the front of the lense assembly, you will need to pop that out... Carefully use a screwdriver to accomplish this...
You can see the white plug of the connector below
SOURCE: how to replace tail light bulb - 05 Honda Odyssey
Yup after removing the 2 screws, there is a round plastic tap.
you need to pop the light housing back and outward with a flat screwdriver. wrapped electrical tape on the flat end to avoid scratching the paint.
150 views
Usually answered in minutes!
×