Where do u put transmission fluid in a bmw 740il 2001

fuse box diagrams

BMW 5-Series (E39; 1996 - 2003) - fuse box diagram ...

https://www.autogenius.info > bmw-5-series-e39-1996-...
Aug 26, 2018 - BMW 5-Series (E39; 1996 - 2003) - fuse box diagram. Year of production: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003 ...
Missing: 740il ‎' Must include: 740il

• 
  

  BMW 3 Series E36 and E35/5 (1990 - 2000) - fuse box ...

  https://www.autogenius.info > bmw-3-series-e36-and-e...
  May 28, 2018 - BMW 3 Series E36 and E35/5 (1990 - 2000) - fuse box diagram · Front power distribution box · Relay carrier under LH side of dash · Connector strip ...
  

Picture & amperage & description of every single fuse ...

https://www.bimmerfest.com > ... > E39 (1997 - 2003)
Mar 1, 2013 - There are SIX fuse box locations in my 2002 BMW 525i E39 (here is a 1997 540i fuse location chart):. EF1 to EF5 <= at the back of the ebox ...

..

have you put a different type of power steering fluid?

in some instance, if they put a different type of fluid, the solution bubbles up and makes a whining noise when you use the car.

tnx 4 using fixya,

drcool

What kind of fluid?

it's located in the pan

Hi there,

Transmission Fluid is the lifeblood of your auto and considered to be the one of the most critical components for a good working transmission, as the chemical makeup & viscosity of the fluid helps determine correct pressure and shifting. For this reason, use only BMW specified fluid - DO NOT use any non-approved fluid.

Measuring correct transmission fluid level is done after the engine/trans has WARMED UP.

If you measured your transmission fluid level using a dipstick, then you generally add BMW spec fluid through the same tube as the dipstick. CAUTION: never overfill the transmission, as excess fluid will cause 'foaming' and this usually creates further shifting issues.

If you have determined the fluid is low, the trans components will still function, but any attempt to operate the transmission in DRIVE with inadequate fluid, will likely cause unneccessary damage.

If there is no dipstick present, then this model BMW (much like the Merc's) denies you the ability to change your trans fluid yourself. This is a precautionary measure by the manufacturer to prevent the owner from changing the fluid. Instead, the workshop will have a special tool to measure the fluid level.

Cheers,


"If this has helped you in any way, please rate this solution"

there is no tranmission fill cap on these models, transmission has to be serviced at a tranny shop.

Hey

They don't put a fill tube on them . It's suppose to be life time fluid. Must be filled from the fill hole and the plug is on the right rear side of the trans.

Hope this has helped
.

try lucas transmission additive.

There isn't one. To check the transmission fluid level there is a plug that you must remove.The fluid should be to the level of the threads. See here http://www.bimmerboard.com/forums/posts/68013 or here http://tech.bentleypublishers.com/servlet/JiveServlet/download/66-15645-136704-1551/ATFCapacity.pdf

put it down the dipstick hole for the trans.