I tried to pull fuse by hand it won't budge
Most fuses are very difficult to remove by hand from an auto fuse box.
There is usually a plastic fuse puller either clipped to the fuse box cover or on the fuse panel itself (usually the inside fuse panel - if you are trying to pull one from the the fuse panel under the hood and you don't see a puller, look in the fuse box in the interior of you Sable).
If you don't have a fuse puller, try a set of electronics tweezers or standard tweezers. Good luck!
SOURCE: 1996 mercury sable speed hand and drives in strain and ****
I hace a 19196 sable-the problem is the transaxle speed sensor-this part sends all speed info to the computer ..-First symptom(speedometer stops working and then transmission shifts erratacially and power steering becomes hard and engine light comes on..The computer on this all eletronic car cannot send proper signals to the speedo-trans-power steering and other functions without knowing how fast or slow the car is going..Have the SPEED SENSOR mounted on top of the tranaxle replaced and all will be well.Part is not to expensive.labor can vary depending whether you have 3.0OHV or DOHC engine-some cars have to have exhaust dropped to get at it-Good Luck All
SOURCE: fuse question
it should be marked on the cover of the fuse box if not find the fuse with broken bar and replace. joe
SOURCE: where do you plg in cd changer on 1997 mercury sable wagon
not all sables had a harness for cd changer . if it had one it would be taped to harness above fuel shut off.
SOURCE: 1997 mercury sable won't shift into overdrive
first of all, check the kickdown cable to transmission. it may be out of adjustment. or just bad.if its the cable out of adjustment, it is sure cheaper then a tranny.
SOURCE: need a diagram of in cabin fuse box
go to this web page and then to the ford site to look this up in the PDF owners manual, it is free, we don't have a diagram at fixya
http://www.edmunds.com/ownership/howto/articles/120189/article.html
175 views
Usually answered in minutes!
×