Can you help to get Timing mark
The timing marks (dots) are on the sprockets.. Make sure you have these lined up perfectly (use a steel ruler) before dismantling anything! Then you will have No.1 piston at TDC (top dead centre) and the job will go smoothly... ok?
SOURCE: can not get timing 2 set
Click on the following free direct Link. It has the Timing: Belt and Mark Diagrams for the 1988 Daihatsu Charade 1.0L 3-Cylinder which is the closest to the Hijet. Plus additional Instructional and Directional Diagrams.
Note: the annotated Align Matings Marks located on the engine casing, or the Belt Alignment Marks.
I owned one of these while living in Japan.
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/1988/make/daihatsu/model/charade/1988_daihatsu_charade_timing_belt_diagram_marks.htm
SOURCE: 2008 Daihatsu Terios engine number location on the car
wow someone knows their stuff ,if not sure where numbers are i ask in our local annual vehicle inspection station ,dont you have one??
SOURCE: timing
Right hand side of engine, small square portal in transaxle housing with a notch plate to line up with the flywheel dimple.
SOURCE: 98 DAIHATSU TERIOS AUTO, 1.3 4X4. REAR BRAKE
drums out of round,or if disc brakes discs warrped,affected by heat need maching at brake place
SOURCE: Cigarette lighter fuse for Daihatsu Terios. Where
the fuse you are looking for is lockated under the dash at the drivers side if you remove the small change hilder you will see it it a blue 15 amp on the right hand side of the box hope this helps
483 views
Usually answered in minutes!
×