Replaced drivers power window motor and reg on 92 honda accord it goes up and down no prob but!! it won't fully close now

SOURCE: 2007 honda accord four door with power windows

if you try to move the windows with the other switches on the other doors and the windows still do not work then replace the drivers door master switch. the circuit for all windows runs through that switch

SOURCE: Power Window Stuck Down On 97 Honda Accord

try going to a junk yard your motor was fine but your controls are not buy the controls and change them hondas do this when the resistance is burned out Junk Yard is the best place to find something simple as this 2 screws 3 plugs basic plug in play deal

Donald DCruz

• 17130 Answers
• Posted on Feb 09, 2011

SOURCE: 1997 honda accord with power windows....driver

Before you change make sure there is power on the board , if so the circuit must be checked for delivering voltage as the switch is pressed. the switch can be checked with a multimeter for continuity. Only if there is power to the motor without response must the motor be changed. if not the fault can be the control circuit board, maybe failure of the motor driver.

SOURCE: Problem with the 1998 Honda Accord Power Window

Looks like you are going to have to take the door apart for inspection. There is a good chance that the half moon jumped a couple of teeth and that the mechanicals between the electric motor and the scissor window raising mechanism is out of sequence. Once the door panel is taken apart, it is a rather simple task, to loosen the scissors, raising the window by hand, and re-tightening after you have shifted the whole assembly a couple of teeth. Remember not to place the window up to the exact top spot, but rather a little higher ( so that the window tries to keep going after it is fully up). This in order to insure a tight rain / road noise seal, the motor will recognize the extra load, and will stop working when the window glass is tight against the top frame.

SOURCE: 2002 Honda accord passenger power window won't go

run power t the motor to see if motor is bad if not pull apart switches and clean contacts or replace