SOURCE: 99 mercedes e320.check engine light on.po341
that appears to be a camshaft position sensor performance code. you can start by checking to see if the sensor is working properly, re-check and make sure that the harness is ok by checking the resistance through the harness if all looks well there make sure the computer has the latest software on it by having it scanned at your local dealer. also you can check the reluctor wheel on the camshaft for damage or debris in the way of the sensor.
hope this helps!
SOURCE: e320 reset SRS
Hi,
Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.
SOURCE: how to replace a water pump on mercedes e320 1997
It is not complicated, depending on what hands-on level of DIY on car. Here are what need to do, so you can estimate how easy or hard when you look through your engine. Drain all the coolant, remove the thermostat housing, remove the fan, belt. Remove the water pump pulley. There are 4 bolts to hold the water pump in place.If you think you can take them out and put them in without removing the AC compressor then you can do it. I did it twice without removing the AC. The pump was fine for the second time, but for leaking seal. At dealer, it is easier to access from the bottom since they have a lifter. But it is doable at home. Have fun if you decide to do it.
SOURCE: I have a 1994 Mercedes E320. My blower fan doesn't work.
The "strip" fuse is in a tootsie roll sized black container on the drivers side strut mount. pop it open and there it is. 2 philips screws hold it in place. Breaks in the fuse are not easy to see.
127 views
Usually answered in minutes!
×