It goes in a hole in the block near the bellhousing
SOURCE: how to Change, back three plugs on a 2003 Dodge caravan 3.3l
you need to put a ratchet ******** the front of the engine and remove the dog bone engine mount this will allow the engine to be pulled forward with strap and you can reach behind and remove the plugs or you can get them from underneath the van hand tightened with a spark plug socket and wrench if you overtighten they will break
SOURCE: locating heater blower motor resistor
the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.
SOURCE: 2005 dodge grand caravan getting code p0406
3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .
SOURCE: how to install egr valve on 2006 dodge grand
You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.
SOURCE: Heater blower motor replacement -1997 Dodge Grand Caravan
Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.
1,186 views
Usually answered in minutes!
×