Question about 2003 Jeep Liberty

1 Answer

Electircal issue with 2003 liberty rear wiper

Not sure but I think I have some expsoed wiring somewhere, when rear lights or brakes lights on the rear wiper starts, as soon as lights closed or brakes off wiper stops.
Since the fuse operates both frnat and rear I cannot disengage, is there a plug for the power for the rear wiper motor?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 66 Answers

Yes right at the wiper motor.

Posted on Jan 26, 2018

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: 2003 Jeep Liberty rear wiper does not work

how is it not working, entirely not running, or just doesn't come in contact with the glass?

Posted on Mar 31, 2009

Anonymous

  • 1 Answer

SOURCE: The two back brake lights went out at the same

Both of my brakelights have gone out on my 2005 jeep liberty. The problem is the brakelight socket. I bought replacement socket from the dealership for about $8 each. They are wireless and easy to replace. They sit on a circuit monted to the back of the tailight. The dealership will need your vin # as there are different types of sockets for the liberty.

Posted on Jan 09, 2010

beth lawrence

  • 1 Answer

SOURCE: Fuse for brake light on 2007 Jeep Liberty

I dont have owners manuel and need to know what fuse is my brake lights ? All brakes lights are out . Thank you

Posted on Feb 11, 2012

rwwood81766

Robert Wood

  • 5733 Answers

SOURCE: 2003 Jeep Liberty rear wiper does not work

Check fuse number 9 a 50 amp fuse in the power distribution center under the hood and fuse number 17 a 15 amp fuse in the junction block . The ground wire near the wiper motor may be bad and its possible the switch position for the rears may be bad.

Posted on Jun 18, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear wiper, defroster and licence plate lights stopped working on my 2007 suzuki swift but when I open the rear hatch the licence plate lights come on . Any ideas what's wrong?bad ground?


[PDF]Wiring Diagram.pdf - Ken Gilbert

ken-gilbert.com/wrx/mans/99.../Wiring%20Diagram.pdf
Each connector number shown in the wiring dia- ... Rear defogger cord (Ground). Fuel tank cord,. Roof cord, ... circuit. Then check the switch, relay, fuse, ground, etc. 4. .....Rear wiper motor. Rear wiper ... License plate light RH. Tail light LH.

#? license plate light - Circuit Wiring Diagrams

circuitswiring.com/tag/license-plate-light/
2008 Volkswagen Newbeetle Main Fuse Box Diagram 2008 Volkswagen Newbeetle ...Parts: rear window defogger, shift lock, battery positive voltage, interior light, A/C clutch, ... brake light, daytime driving light, wiper and washer system, vacan, fuel pump, central ... 1997 Suzuki Geo Tracker Left Dash Fuse Box Diagram.

#? license plate light - Circuit Wiring Diagrams - Page 3

circuitswiring.com/tag/license-plate-light/page/3/
Audi A4 Engine Fuse Box Diagram Audi A4 Engine Fuse Box Map Fuse Panel ... mirror control, wiper, washer, horn, brake light, cruise control, heated rear window, ... 2003Suzuki Aerio Dash Fuse Box Diagram 2003 Suzuki Aerio Dash Fuse Box ... rear defroster, fuel injection controller, radio, A/T controller, hazard light, ...

Jan 05, 2016 | Suzuki Cars & Trucks

1 Answer

Brake light and turn signals


check to see if the wire connector is plugged in properly

May 30, 2013 | 2003 Jeep Liberty

2 Answers

Only rear driver side brake light will not work when braking need help


Pastor Norman, Pastor Dave here.
Since you already replaced the left rear brake light bulb and that didn't help, please take that bulb socket out again as you did before, and find a way to test the bulb contact for electricity when the brake lights are on. You should get 12 volts out of the "hot" metal contact.
If the other two lights are on, and you have no current in the socket, you either have a bad socket, or a broken wire somewhere.
One way is to go back a few inches and skin off the insulation of the brake light wire and see if there is current back a few inches from the socket. Cover with tape when you finish.
If you decide to cobble a solution, you could run a good wire from the other brake light that works and splice it in to the dead wire.
Be Blessed.

Jan 23, 2013 | 2007 Toyota Corolla

1 Answer

Brake fuse blows as soon as replaced 2001 ford taurus


That usually means short to ground..Look for a wire touching the frame or the body of the car somewhere..Check around the brake switch which is located on the brake pedal...Disconnect the connector and try the fuse again..If it doesnt blow then i would think the switch is bad..Also check around the brake lights and make sure the wires look ok..That is if your talking about the brake light fuse

Sep 22, 2011 | 2001 Ford Taurus

1 Answer

Jeep Liberty '03...need to repair rear window washer/sprayer and probably tube....that snapped off. Parts needed? Access through bumper?? Thank you for ANY suggestions.


Not so simple procedure, try and follow all your steps and replace all screws...Not familiar much with the Liberties but, usually access to the wiper will be somewhere in the back of the hatch. You can pretty much figure it out from there.

Apr 27, 2011 | 2003 Jeep Liberty

1 Answer

HOW DO YOU REPLACE THE REAR WIPER MOTOR ON A 2003 JEEP LIBERTY?


REMOVAL
  1. Disconnect and isolate the battery negative cable.
  2. Remove the rear wiper arm from the rear wiper motor output shaft.
  3. Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel .Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
  4. Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel
  5. Remove the bezel and gasket from the rear wiper motor output shaft.
  6. Remove the trim panel from the tailgate inner panel.
  7. Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
  8. Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle
  9. Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
  10. Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
  11. Remove the rear wiper motor and mounting bracket from the tailgate as a unit.
To Install just reverse steps

Jan 23, 2011 | 2003 Jeep Liberty

1 Answer

Rear lights, brake lights and turn signals do not


I would check if they also run off of a relay, You could have a wire that is either broke or it is grounding out somewhere.

Feb 05, 2010 | 2005 Jeep Liberty

1 Answer

Ford focus wiring


same thing happened to us.  My wife came home and said the rear brake lights were stuck on so I assumed it was the brake switch...not so. Took car for a ride and noticed rear wiper did not work and when I hit the brake the rear hatched opened and door locks blew out.  I started by looking at the wires in the gromet above the hatch and found almost all the wires were bare.  Therefore power was jumping  the bare wires and traveling back down the third break light and to the rear brake lights and visa versa.. a very dangerous situation.  The best that I can tell is the wires are so short in length that they pull and chafe every time you open and close the hatch...very poor design...   Note: we bought our vehicle brand new and some of the wires had electrical tape on them....seems mickey moused.

Jan 26, 2010 | 2003 Ford Focus

Not finding what you are looking for?
2003 Jeep Liberty Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...