Could be clogged fuel filter which is located in the primary fuel tank module.clogged fuel filter or fuel pump failing.check for fuel pressure see if you have fuel pressure.if fuel pressure okay problem could be ignition timing off which controlled by ECM.need code scan vechicle see if problem in the CKP SENSOR OR CMP SENSOR OR ECM.your vechicle a timing light can be used and a scan tool must be used. with timing light and scan tool your correct timing should be 10 - 16 degrees BTDC.if timing not correct problem could be faulty CKP sensor or CKP sensor plate. faulty TPS sensor. faulty CMP sensor.or CMP sensor rotor tooth of camshaft.fault in the wheel speed sensor worn timing chain.code scan vechicle first before buying new fuel pump.scanning vechicle save time and money.
Sounds like a bad fuel pump
SOURCE: suzuki grand vitara 2.0 TDI
check ignition system, clean fuel system, check all sensors
hope this helps
Thanks for using Fixya
SOURCE: instruction manual for suzuki grand vitara 2004, xl7, V6 needed!!
Hope This helps you.
Suzuki
To order Suzuki service manuals, contact:
Helm, Inc.
Manual Distribution Department
P.O. Box 07280
Detroit, MI 48207
(800) 782-4356
(313) 865-5000
fax: (313) 865-5927
SOURCE: Suzuki Grand Vitara Oil Filter Replacement Disaster
Four or six cylinder engine and behind or front of the oil filter? Looked under my GV 2007 2.7 V6 and can not locate a shiny metal box next to the oil filter. Only thing that was shiny was the exhaust manifold and oil sump which are quite hard to break or puncture. If it was the oil sump you will have to remove it and get it welded as a bog will not hold on heated engine parts.
SOURCE: cabin filter element location
Filter is located behind the glove box. All you need is a screwdriver to replace.
1. Open the glove box and empty to take the weight off the box.
2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.
3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.
4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.
5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.
6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.
7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.
SOURCE: where is located Fuel Filter in suzuki grand
FUEL FILTER IS LOCATED IN THE PRIMARY FUEL TANK MODULE.
549 views
Usually answered in minutes!
×