CAR NOT IN REALLY BAD SHAPE JUST NEED TO FIND OUT IF I CAN REPLACE MY AIR BAG ON DRIVER SIDE...2 DOOR 1994 DODGE SHADOW
Easy to replace two bolts one the back of the steering wheel 10mm I think, call the dealer and junk yards not sure of the cost.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/edward_020b3320326d263d
thank you!!!! are front bumpers easy to fix??
Thanks for reminding me you need to have the front impact sensors checked to make sure they don't need replacing and always disconnect the battery when working on that system. Autozone maybe able to check the codes and they will do it for free.
The front bumper is a cover it is a little harder to fix
i posted above" about bumper......just loose.
They have clips that hold it on, the clips or the the brackets that hold the clips maybe broken
ohh dangg...well ill get it checked out.might be cheaper just to buy a new/used car
As long as it is not falling off, duct tape works good
×
SOURCE: My 2000 Dodge caravan's Horn/Cruise control and Air bag light
You have a clock spring problem!!! No problem to replace just remove steering wheel but you may want to make sure the steering column is grounded first
SOURCE: 2 things. how do i replace the brake light on my
The vehcle has what called advanced qirbag system. It has weight sensors on the passenger front seat. This is for if you have a small child undeer 30 pounds in the front seat the airbags will not deploy. Try sitting in the seat with the car running if the light go out that is why. If it does not have the dealer recalbrate the weight sensors. P.S. don't put small this on the seat like boxes or books that will throw the calibration off. hope this helps.
SOURCE: 1994 Dodge Caravan driver's window won't close.
Start by removing the plastic insert at the door handle. This can be pried out with a screw driver, remove the door handle, prior out the plastic tabs, remove the screws there will be approximately four or five screws, lift the panel up and pull awar from the door. Remove the door regulator, you do this by using a punch and pundh out the rivets, then you drill out the aluminum holding in the glass using 1/4 inch drill bit, remove the door regulator and check for damage, you also need to remove the door motor and take it apart. The door motor will have three plastic plugs in the motor remove these, you can purchase new plugs at any auto store for $8.51, howevwer I would recommend you replace with ball bearings which can be purchased for $.64 cents each at any hardware store, pack the motor with wheel bearing grease and replace. You will need 1/4 inch bolts and lock washweer and nuts to replace the door regulator. Normally the switch will not be the problem. I would recommend you replace all the door regulators and rebuild all the motors. If one is going bad the others will follow. Expect to take allday to complete the job. Door regulators can be purchased on line for around $18 to 30 dollars. Good luck.
SOURCE: Automatic Sliding Door problems on 2005 Dodge Caravan
We have the same problem, just opposite doors - the passenger slider will close to 80%, but the driver still functions fine. There must be an easier solution than new wiring harness/motor??
SOURCE: Broker Dodge Nitro Door Handle
I had my hadle break the other day. I went to the dealership and they wanted $170.00 to replace. The door handle was $60 by it self (for a piece of plastic)!! I read a solution on here that used epoxy putty (JB Weld for Plastic) find it at your hardware store and it worked. Pushing the latch out to touch the handle, I used the epoxy putty on the break and taped the handle to the door to apply pressure and now it's strong as steel. I spent $5.50 for the epoxy putty and saved over $160. Let another handle break, I'm ready!!!!
243 views
Usually answered in minutes!
ok thank you! The bumper is still on but its really loose but lights still work and all
×