Timing mark for a 3ct toyota esmtima 1992
SOURCE: Toyota emina/estima. no manual available
Toyota 2.2 TD engine type: 3C-TE
General: Allways check the timing marks before timing belt removal!
Instructions:
1. Remove the ancillary drive belt
2. Remove the timing belt upper cover
3. Remove the glow plugs
4. Turn the cranckshaft to TDC for cylinder 1
5. Remove the crankshaft pulley centr bolt
6. Remove the crankshaft gearwheel
SOURCE: need to know the timing marks on 1992 toyota
you may find them online but if it were me i would go to local auto parts and spend the $24.95 on a haynes repair manual it has pictures of the marks and the tension specs etc worth the $$ , remove #12 spark plug and take a peice of wire stick it into the hole till it touchs the piston then rotate the crankshaft till its a top dead center then look down at the line up marks behind the crank gear they should line up then rotate the camshaft till marks line up should be 12 oclock on cam gear? this is sometimes tricky to get it lined up without it being 1 tooth off thats why picture is best ? hope this helps [email protected]
SOURCE: How to setup the timing mark for 1996 Toyota Estima 2.2 disel
the only timing mark are on timing belt newer cars dont use a timing light because it is electronic and fixed
SOURCE: toyota estima
My 2.4 estima engines produced hunting and minor knocking sounds in every morning starts or after a long break/ overnight. But it reduces after 15minutes driving. Engine oil level was normal.
2,104 views
Usually answered in minutes!
×