Door Handle I got the panel detached but it is still connected by the window crank. Anyone know how to take that off a Hyundai accent?

I have a 2004 accent and I was able to get the window crank off using the method shown in this video.">

The accent uses a roll pin, not a c clip. you have to drive out the roll pin to remove handle.

take a shop towel and pull it under the crank handle. then rotate rag to snag clip. it will fly off so keep an eye out for it. to reinstall put clip on handle then simlply push it back on

yes remove the panel, unhook the linkage one for the lock and one for the latch remove linkage from the handle not the latch, then remove blots holding handle then remove handle from outside the door, you will have to swap the lock to the new handle and then install new handle.

Look under the round part of the handle,see if there is a small allen screw there,if it is unscrew it until the handle comes off.if not send a new message

Hi

Please follow these steps :

1. Remove the 4 screws and the screw in the opening mechanism.
2. Remove the cap on the lock button.
3. Remove the mirror lever cap by pulling it straigt out. It is attached with one clip.
4. Remove the door crank by detaching the C-clip between the spacer and the door panel. It's tricky and somekind of hook could be useful.
5. Pull out the plastic clips. Be careful. I think a spatula could be a useful tool.
6. Move the panel forward and up to remove the opening mechanism from the door. Then pull the mechaninsm out from the panel, turn it and push it back through the panel.
7. At this point the panel should be removed and you can see the door speaker and the adaptor. As you can see the opening mechanism remains on the door.
To put the doorcrank back just put the pieces together in the picture and push it in position.

Good luck and Do rate the solution as FixYa if found useful.

Thanks
Rylee

The Window Crank Is Held On By A Snap Ring Get A Flat Head Screw Driver And Push On The Door Panel. The Pushing Should Cause The Snap Ring To Be Easily Seen Push On One End And It Should Come Off. Hope This Helps. Also If You Google It They Say You Can Use A Rag But Ive Never Had Any Luck With It.

If no screw in center of handle, push in on door panel & look behind handle for a clip snapped into back of handle. They have a tool for removing if you can't get to it, which should be pretty cheap at auto parts store.

there will be a wire clip at the back of the winder, you will be able to push this out using a trim fork, or 2 thin screwdrivers.

push and move it to the front