Will the light go off, can I have the auto parts store reset it if it doesn't. What do I do? It was never on until I changed the battery.
SOURCE: I changed batteries in my 2003 GMC Sierra key fob
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
SOURCE: 2008 gmc acadia low beam light bulb changing
how do you change the low beam light bulb on the 2008 gmc acadia
SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem
your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps
Testimonial: "Very good information. THANKS!"
SOURCE: Got oil cahnged and now change oil soon light is
Turn the ignition on and within a few seconds slowly pump the gas pedal three times. A message displaying "oil life reset" should show up in the drivers information center. If you have the "newer" driver information center look for an "i" button and scroll through it until you see "oil life **%" displayed. At that point press and hold the reset button until it resets to 100%. Should take about 10 seconds of holding the button.
There should be instructions on how to reset it in the owners manual if this doesn't help. Good luck.
SOURCE: I need help in changing headlight bulb on 2008 gmc
You have to remove the air intake filter and then kind of reach around up in there to change it. It can be done, but is a lot of work. On the duramax, it is even harder to do the driver side because of the dual batteries. You have to remove the battery, then the battery seat plate, and undo the winshield washer fluid tank and lean it forward. Then you can just sort of reach in and change both headlights. A very big pain to change a couple of headlights, but if you want HID's.... for the average person, changing a headlight now means a trip to that garage.
721 views
Usually answered in minutes!
×