Where is the keyless remote receiver on my 1996 jeep cherokee?
On my cherokee its in the dome light housing google it
or google grand cherokee forums
SOURCE: 1996 Jeep Grand Cherokee wiper arm
The little blade lock will lift up. see image..."http://econtent.autozone.com:24991/znetrgs/repair_guide_content/en_us/images//0900c152/80/0a/9d/4c//medium/0900c152800a9d4c.gif"
SOURCE: 1996 Grand Cherokee keyless entry problem
That remote should not be able to be programmed by you, it needs to be programmed by the dealer using their computer. I know that some later and earlier models can be programmed by the user, but I did some research on this as i have a 96 as well and it seems the 96 was a dealer computer thing. If you in fact bought the remote from the dealer they should be willing to program it for FREE. Otherwise I was given a $30 estimate for the programming.
SOURCE: keyless remote transmitter programming
You will have to have a Jeep/Chrysler/Dodge service tech hook up their programed OBD2 scanner to reset.
SOURCE: 1996 Jeep Cherokee electrical schematics and 1998 jeep cherokee
I need the bulb for the roof light for the 1996 Cherokee
Unlock all of the Jeep
Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
396 views
Usually answered in minutes!
×