At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Truck wont start bang computer starts right up sometimes cuts out when driving bang computer starts up again 1995 57 vortec 1500 what do you think one day will bang sure wont start help
replaced with junkyard ecm had same problem no burnt pins pins all straight trying another ecmreplaced with junkyard ecm had same problem no burnt pins pins all straight trying another ecm
You can't post conmments that contain an email address.
SOUNDS LIKE YOU HAVE CONECTOR PROBLEM .CHECK ALL CONECTIONS AT COMPUTER. SPECIALLY POWER AND GROUND . CHECK FOR BURNT PINS AT COMPUTER . IF ALL GOOD YOU SHOLD REPLACE ECM.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sounds like it could be a dirty or faulty idle air control valve.Take it off and clean it with a wire brush and a non-chlronated brake cleaner or replace it with a new one.Make sure you reset the computer after cleaning or replacing the valve.
I have had this problem on my 89 and my 94 gm trucks what it was is the pick up inside the distributor time to rebuild it (not the cap and rotor) the little thing inside with all the wire wrapped around something- copper wire with a clear coating on it the coating get hot and cracks causeing it to ground out when the vehicle warms up run ok until u shut it off then no start or runs rough
check your rear brake shoes if you had them changed recently they may not have been adjusted properly and that sometimes will cause that and also check the rear diff yoke where the driveshaft goes insometimes it get gear oil on it and harder for it turn. i would try these hints first before i take to shop
replaced with junkyard ecm had same problem no burnt pins pins all straight trying another ecm
×