I want to clean my maf sensor in my cadillac. My question is can i spray the crc cleaner into the sensor while it is mounted to the engine or do i take it off which means that i will need to replace the gasket. What would be the precedure?
SOURCE: need to replace turn signal switch 93 cadillac deville
First do you have a sterring wheel puller. Can't remove the steering wheel without one. Quite an involved job including snaking the electrical connector end through the steering column. I wouldn't recommend it to the novice
SOURCE: 2002 Cadillac Coolant sensor
The engine coolant temperature sensor is located on the driver side of the engine near the rear of the engine compartment
SOURCE: replacing a radiator in cadillac deville northstar 1997
a drain pan, a hose release tool, flare nut wrenches and simple hand tools, such as a set of wrenches (sae and metric) and sockets with a variety of extensions. it would be helpful to have both 1/4" and 3/8 inch drive sockets and ratchet's
SOURCE: 1994 cadillac deville concours
On my car, which is the same as yours, it is located on the manifold top back left. Pictures in the book just show it on top.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
118 views
Usually answered in minutes!
×