I NEED DIAGRAMS FOR SETING UP TIMING CHAIN MARKS CHAIN ALL READY IN CAR TIMING IS OFF CHECK ENGINY LIGHT ON
The chain has a total of82 links. You should have at least 1 link that is marked. Place that one on the mark of your crankshaft. Now going up to the intake side there will be 29 links between the cam colored link and the intakes colored link. Now go up the other way to your exhaust cam. There will be 34 blank links and then the colored one for the exhaust cam. Afterwords you should have 11 links between the marked cam links. I hope this will help all of the dozens of folks who had or has the same issue.
Hi Robert,here's a link to your timing chain marks, Repair Guides Engine Mechanical Components Timing Belt Sprockets AutoZone...
SOURCE: timing degree nissan sentra
Step1 First step is to open your hood on your vehicle and locate the distributor. Step2 Next loosen your distributor just enough that it will turn from side to side with some resistance. Step3After Loosening the distributor take a piece of chalk and mark on theharmonic balancer the timing mark so it can be seen easily. Step4Then take the timing light and connect it to the battery and the Numberone spark plug wire. Then have your helper start the vehicle while youshine the timing light on the harmonic balance and the timing mark onthe timing chain cover. Step5The Timing Light will illuminate the mark on the harmonic balancer whenthe Number one cylinder is firing. The mark should correspond to thetiming mark on the timing chain cover. You can then adjust the timingforward or backwards by rotating the distributor ever so slightly. Step6 When you have the timing where you want it then shut off the engine and carefully tighten back down the distributor without moving it.
SOURCE: desparetly need diagram for 1990 volkswagen golf 1.8 timing marks
http://images.eurotuner.com/images/eurp_0801_07_z+2001_vw_golf_1-8t+1-8_liter_20v_engine_atp_gt28rs_turbo_vf_engineering_engine_mount_usrt_genesis_415cc_injectors.jpg please rate me!!
SOURCE: 1999 Ford Expedition 5.4L Timing chain setup
.
Remove the two bolts, the timing chain tensioner and tensioner arm.
NOTE: LH shown; RH similar.
Remove the bolts and the timing chain guides.
Installation
CAUTION: Do not compress the ratchet assembly. This will damage the ratchet assembly.
Compress the tensioner plunger, using an edge of a vise.
If the copper links are not visible, mark two links on one end and one link on the other end, and use as timing marks.
If removed, install LH and RH crankshaft sprockets.
Position the tensioner arms and tensioners, and install the bolts.
SOURCE: 1999 Nissan Sentra GXE timing belt/chain maintenance
good day Sir, your nissan sentra 1999 gxe have a timing chain this is some tips for your routine maintenance.
Replace engine oil
Replace engine oil filter i
1,136 views
Usually answered in minutes!
82 links total. 29 blank links between the intake cam mark and the crank timing mark. 34 blank links between the crank mark and the exhaust cam mark. Then you should have 11 blank links between the cams. Your welcome!
×