SOURCE: No electric windows, mirrors, or door locks
Look in the Engine bay fuse box at Fuse #12 this should be for the power windows. If this checks out OK, it could be a fault with a bad ground wire in driver's side door harness. You should be able to pry the runbber boot from the drivers door, and check the larger Black wire that goes through it. These have been known to break after a few years use. If it is the cable, cut neatly, strip the ends anu use a crimp splice. Hope this is a quick and easy fix for you. If it helps you solve the problem, Please take a moment to rate as Fixya! Thanks.
SOURCE: Door mirror fitting on S80
The mirror slides out , away from the cabin, Retained by spring clips.
SOURCE: Replace outside rearview mirror on 2009 Honda Fit
not usually. if you look at the very front of the door next to the winsheild, you may see a small plastice peice. that peice just POPS off and gives you acces to the mirror bolts and plug ins
SOURCE: how do I replace offside
didnt know they made a ford focus in 1956 ,they still made the MK1 zeyphr and zodiac then the ford consul didnt come out till till 1957 ,so i assume its a modern focus and to change a mirror is a simple job just pull the triangular trim off the inside of the door at the back of the mirror and you will see three screws ,you should be able to unplug the multiplug without taking the door panel off undo the screws and the mirror come off .
SOURCE: Fitting single towbar electrics, Hyundai Coupe 2.0 2004 (Tiburon)
Hi There. Im not sure where you are but this is the sequence for the UK< Hope it helps.
here are the 7 cable locations and pin numbers.
Pin 1 Yellow L/H Direction Indicator
Pin 2 Blue Rear Fog Lamps
Pin 3 White Earth Return
Pin 4 Green R/H Direction Indicator
Pin 5 Brown R/H Tail & No, Plate Light
Pin 6 Red Stop Lamps
Pin 7 Black L/H Tail & No, Plate Lights
I found the easiest way to locate the correct wires in the loom is to turn on the lights required and use a circuit tester and splice into the main loom where you have enough wire to play with. Try not to cut the loom as it only causes more problems with bad connections and joins.(
Good Luck
62 views
Usually answered in minutes!
×