1996 honda accord LX auto trans problem

check the instillation of the transmission shift cable, it needs to be adjusted so that the pawl on the trans case has a full range of motion-put the shifter in neutral, and manually put the pawl in the neutral position (disconnect the cable0-then connect the cable again and bolt it into position.

You'll have to have the trans pulled and rebuilt

With all that slipping, it is beyond any other fix

My daughters car was shaking so bad when she turned it on this morning. What could it be?

Sounds like radiator problem mixing coolant with oil. Will need to change rad, flush transmission thoroughly to remove contaminated fluid, being sure torque converter flushed as well, then re-assemble everything, & put new fluid & filter in transmission, and hope like heck, too much damage hasn't already occurred. This might be a job for a tranny shop that can flush that system properly, if you have one in area that you trust.

CV joints worn. Remove and replace.

Toyota shares the same problem. when the light blinks it means the overdrive feature in the trans is malfunctioning. Sooner or later it will lead to bigger trans problems. Accords are well known for trans problems.

D4 is drive with over drive when overdrive switch is press in/on position on shift. Good luck and thanks for using FIX YA

I believe there was a recall about that:

Recall Summary THIS IS NOT A SAFETYRECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED ASAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION:PASSENGER VEHICLES. THE ACCELERATOR PEDAL FEELS ROUGH OR NOTCHY WHENYOU PRESS IT.

http://www.internetautoguide.com/auto-recalls/09-int/1996/honda/accord/index.html

If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.

You need to change the clutch pads on the cars for a smoother drive...............