2000 Jimmy power windows

with key on door open, hold switch in down position and rap door panel with rubber mallet...if it works, need motor, if not, check switch for power

With key on door open, hold switch in down position and rap door panel with rubber mallet...if it works, need motor, if not, check switch for power out to motor

check for broken wire inside boot at door jam

Inspect or replace the window lock and unlock switch on the drivers door power window switch. There is a lock and unlock switch that will disable the switches to the other power window in the Jimmy. Check to make sure that switch is in the unlock position to have the other power window switch to work.
Thank you for suing fixya and good luck.

the driver side is the main source of power 4 the windows. you will need 2 replace the electrical board on the door for the windows. try running a wire from the battery to the fan on the positive. if the fan comes on check the relay. if not bad fan

if the drivers side switch is the only one that doesnt work it needs replaced confirm by making sure the passenger door switch works the passenger window

Have you tried taking the door apart to see if the connection has come loose or off completely?  That is where I would start as long as the controls on all the other doors are working properly.

The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.

I had the same problem...it was the window gear that got stuck when the window was all the way up. (that's the clicking) I took my panel off and banged on the inside of the door with a rubber mallet. The window works again. Since then I make sure when I role the window all the way up to stop that I just barely tap the down button to release the pressure on the gear inside. When your using the hammer...hold the switch in the down mode...ignition on of course.

It's either the passen. side window switch OR the lock function on the master switch assembly isnt right or a pinched wire that goes thru the door jam.

Try "playing " with the master switch while someone else tries the other side window switch. Also ...check for pinched wires in the door jam boot.