Exact location of the drain plug for transmission on 2008 hyundai accent?
SOURCE: location of horn on 1998 Hyundai Accent
hi not aware of whether or not you solved horn problem? ie location but for info you will find horn just in front of the crossmember in front of radiator (where the bonnet closes onto ) horn is on the nearside looks like a disc secured by a nut+washer it has a plug on wire connector ps these horns are prone to fault but you might try tapping the horn gently with horn operated/pressed you can purchase a more reliable wind tone/horn and fitto same bracket and replace the terminalplug to connectors for new type easy diy check E BAY for hornes on car accessories ? hope this helps?
SOURCE: hyundai accent, location of fuel cut off
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
SOURCE: location of oil filter on a 2008 hyundai elantra
It is located under the alternator. If you are looking down at the engine, it is to the far left. If you are under the car it is to the far right before the oil pan.
SOURCE: 2005 Hyundai accent overheating, radiator
A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.
SOURCE: where are the spark plugs
You have to remove the oil filler cap and then remove the fancy black plastic cover which is labeled "DOHC 16V" and which has the Hyundai emblem on it.
368 views
Usually answered in minutes!
×