How do you turn off the service engine soon light on panel

Service Engine Soon

If the Service Engine Soon indicator light stays lit after you've started the engine, the On Board Diagnostics system (OBD) has detected a malfunction of the vehicle emissions control system. Contact your authorized dealer as soon as possible.
If indicator light is blinking, an engine misfire may be occurring, which could damage your catalytic converter. Drive in a moderate fashion (avoid heavy acceleration and deceleration), and have your vehicle serviced immediately.*
The Service Engine Soon indicator light illuminates when the ignition is first turned on (prior to engine start) in order to test the bulb, as well as indicate whether the vehicle is ready for Inspection/Maintenance (I/M) testing.
Normally, the Service Engine Soon light will stay on until the engine is cranked, then turn itself off if no malfunctions are present. However, if after 15 seconds this light blinks eight times, it means that the vehicle is not ready for I/M testing.Check this link out Gary.
https://owner.ford.com/how-tos/vehicle-features/dashboard-instrument-cluster/warning-lamps-and-indicators.html

Your starter switch is faulty

the check engine light alerts you that there are problems. There will be a code or codes stored in the engines computer. You can retrieve these codes one of three ways.

1. call your local auto parts store. Many times they will do this for free.

2. buy an inexpensive code reader. Available just about anywhere that has an automotive department. They will start at about $50.

3. Bring it in to a shop to have a check engine light diagnostic done.

Once you know the code you can then start to focus on a repair. Once a repair is made the codes will be cleared and the check engine light will turn off. If you do not make the repairs the light will not stay off. It will continue to come on and stay on until the proper repair is made.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

replace the air and, fuel filters

the anti-lock and traction lights will come on together if there is a common problem with the two, since they are closely related. may be a wheel speed sensor or something similar. the service engine soon light indicates a problem with the engine computer, can be anything from an emission system problem or an engine performance problem. all of these lights can come on with no apparent running problems on the car. the service vehicle soon light is basically a maintenance reminder, an oil change light. take the car into a shop and have the codes read for these lights.

The Service Engine Soon indicator light tells the Service tech that the Pathfinder's ECM detected and Issue with the engine's management system. Your going to have to get the Pathfinder Scanned for DTC codes so you can addressed the issues that is in the ECM's history. Once the issues have been addressed, the Service engine light will reset it self or the service tech can reset it for you. The light will stay on or come back if the issues have not been repaired. Good luck and hope this helps.

you will need to take it in for a diagnosis scan. this Will scan for trouble codes that will direct you and your mechanic to the issue at hand. it will also tell you how to fix this issue as well. once this problem is fixed, the light will shut off.

In most cases, it a failed sensor of some sort. most auto zones will scan the ecm for free.

oh thats the change oil light expect it every 3500 to 4500 miles they glow.. you can usually reset it by holding down the trip button with the car off and then turn the key to the II position where everything lights up
so read me >>>>>
Buick Rainier 2004-06, Buick Rendezvous 2002-05 w/o (DIC) Driver Information Center
Turn the ignition to ON without starting the engine. Fully press and release the accelerator pedal three time in five seconds. If the CHANGE OIL SOON’ indicator flashes two times, the system is resetting. Turn the key to OFF, then start the vehicle. If the CHANGE OIL SOON indicator comes on and stays on for five seconds, repeat the procedure.
Buick Rainier 2004-05 wI (DIC) Driver Information Center
The DIC display is located on the instrument panel cluster above the steering wheel. The DIG buttons are located on the steering wheel. Press button with the gas pump symbol to display engine oil life. Press button with the arrow symbol to reset engine oil life display.
Buick Rendezvous 2002-06 wI (DIC) Driver Information Center
To reset Service Reminder Indicator, turn ignition on with engine not running. Press the MODE button until DIC reads oil life left hold SET to reset. Press and hold the SET button until 100% is displayed. You will hear three chimes and the change oil message will go out. If the CHANGE ENGINE OIL’ message comes back on when the vehicle is started, the engine oil life system has not reset. Repeat the procedure.

The reason for the light to come on an the after you have switched the vehicle off and back on again and the engine light stays dead is because the control units of the vehicle will reset when the ignition is switched off for 10sec. If the light stays off the it might be that the car got a wrong reading from a sensor and caused the engine light to come on. If it was a serious problem the light would have come on again

If your battery starts turns the engine over, it is doing it's job well. It sounds like your engine computer is not liking the cold engine. If it has been a while since a tune up, it would not hurt to go ahead and do it, but if it runs ok after it warms up, I sould not worry about it a whole lot. When the engine is cold, the egr valve and other things that are made to limit polution tend to stick and give the computer bad readings. A serious tune up may fix it, and I think should, but you MAY still be in the same boat! That does not FIX it for you, but should ease your mind on the light.