Adjusting headlights
SOURCE: 2006 Pontiac G6-GTP How do I adjust the headlights.
to raise you headlights there is a small brass allen screw located above each headlight under the hood. to raise your headlights turn clockwise until they reach the desired level.
SOURCE: low beam headlights not working on 2004 Pontiac Montana extended
You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.
I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp
SOURCE: front headlights
theres two bolts on top of the lighting housing that you have to remove first. in the back corner of the housing there is a ball and joint that you have to slip out this will remove the housing from the car. on the back of the housing there is three circlular disks that u can twist off which will expose the bulb. repeat these steps in reverse to reinstall.
SOURCE: 2001 pontiac montana headlights do not shine very
There could be two reasons for the headlights to not shine too well.
1. The bad reflectors (unlikely as Pontiac could not have given you reflectors that could go bad in 8 yrs as they are sealed).
2. Low voltage/amperes in the light circuit (very likely as there could be a faulty/insecure connection). As time passes, the joints and connections can get rusted and thus produce an impedance in the circuit. And thus cause the brightness to reduce.
You must check for 2 above from the lights to the battery, including the switches en-route, and wherever you have doubts you must cur and peal then tighten the screws. It would most likely be at the bulb end as that is exposed to the vagaries of weather.
SOURCE: changing headlight on pontiac montana
Open the hood.
Remove the front turn signaVparking lamp
assembly
Pull the assembly away from the vehicle.
Unscrew the black retainer ring that holds the bulb
assembly in place.
Pull the bulb assembly straight up from the lamp
housinq
Unhook the electrical connector by lifting up the
blue tabs and pulling the bulb out.
818 views
Usually answered in minutes!
×