I need to replace my right front fog light on my 2004 Santa Fe V6.
I'd like to know how to do it as there is no obvious access to it
Thank you
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
Light bulbs are usually accessed from the rear of the bulb housing. Locate the plug/socket with two wires going into it, rotate 90 degrees and pull socket and bulb out of the back of the fixture.
Pull old bulb out, push new bulb in, and reverse the above procedure to reinstall. DO NOT TOUCH THE NEW BULB WITH YOUR FINGERS. USE THE PROTECTIVE BULB COVERING TO HOLD THE BULB.
1,540 views
Usually answered in minutes!
Been told I need front left wheel bearing replaced on 2003 Santa Fe.what should cost be?
×