SOURCE: electric fuel pump inertia switch?
On a 1992 Daihatsu Rocky where would you find the electric fuel pump inertia switch?
SOURCE: electric fuel pump inertia switch?
where is the fuel pump pressure switch located no 1992 z28 camaro. also there are 3 wires coming out to fuel pump at back of car pink grey brown what do they go to.
SOURCE: need to replace bank 2 sensor 2 on 2003 toyota
Bank 2, sensor 2 is a heated O2 sensor located below (after) the catalytic converter on the passenger-side. When this sensor gets clogged and/or goes bad from rust and heat fatigue, the voltage drops low enough to cause the electronic control module to register error code P0161, which then causes the check engine light to come on.
To replace Bank 2, sensor 2, remove the debri shield from just behind the front bumper, underneath the vehicle. There will be 10 bolts holding it on (10mm, I believe). After removing it, look toward the center of the newly exposed area and you will see 2 finger-like objects projecting out from the engine with wires coming out of each. The one on the left (passenger-side) is bank 2, sensor 2. The one on the right (driver-side) is bank 1, sensor 2.
I got my direct-fit sensor online for $55 from Remart Auto Parts. I know it is tempting to get the universal-fit type and save the cash. But after doing that once, I wouldn't care to do it again.
I found a YouTube video showing pictures of where the two lower (after catalytic converter) sensors are located. While the video only points out the driver-side sensor (bank 1, sensor 2), it's easy to spot the other one being only inches away.
http://www.youtube.com/watch?v=TgQtZci2oOg
If anyone has found this helpful at all, please vote for me.
SOURCE: e-150 fuel pump inertia switch location
on some fords it is on pass side kick panel you have to feel in a hole and you will feel a reset button,hope this helps
SOURCE: where is the OBD connector on a 2003 toyota highla...
It is located on the bottom of the Driver's side dash, below and to the left of the steering wheel. The connector is recessed about an inch and has a black cover that has "OBDII" imprinted on it.
693 views
Usually answered in minutes!
×