Right-side power windows will not roll down

there is a power window motor plus a regulator

The power windows on your vehicle are controlled by an electronic control module , as are the power mirrors !
Power Window System Components
The power window system consists of the following components:
• Driver door module (DDM)
• Passenger door module (PDM)
• Body control module (BCM)
• LR power window switch
• RR power window switch
• Window up and window down relays in each of the rear passenger window switches
• Window lockout switch
• Reversible power window motors in each of the doors (circuit breaker protected)
• LT DOOR CB 25A (System power for left rear window)
• RT DOOR CB 25A (System power for right rear window)

Your best bet , take your vehicle to a qualified repair shop.

This problem is very likely caused by the drivers side power window switch being defective, I have seen this very same problem in the shop more than once and the new master switch fixed it. here is the part number and price from www.Rockauto.com
AIRTEX Part # 1S3874-Left front Power Window Switch. Price $105.79

sounds like the alignment on the windows is bad just my thoughts

REMOVE THE DOOR PANEL TO GET TO THE WINDOW MOTOR. REMOVE THE CONNECTOR ON THE MOTOR. LOOP A TEST LIGHT FROM BOTH TERMINALS. WITH THE KEY ON AND BOTH SWITCHES IN PLACE, CHECK TO OPERATION OF THE SWITCHES. IF THE LIGHT COMES ON IN BOTH DIRECTION THE WINDOW MOTOR IS BAD.

THERE IS A CIRCUIT BREAKER BUILT INTO THE WINDOW MOTOR. SOMETIME HITTING THE MOTOR WITH MAKE THE CIRCUIT BREAKER RESET BUT THE MOTOR WONT LAST LONG DOING THAT.

ALSO TRY PULLING DOWN ON THE WINDOW WHILE TRYING THE SWITCHES. THE WINDOW COULD JUST BE STUCK. THIS HAPPENED TO ME.

No won't be fuse. My guess is there is something faulty with the main controller. You could probably verify this by trying the switch on right rear passenger door. If it works there then the problem is at the main controller in the driver door. Could be a loose wire or the switch itself is broken.

most of the time it is wires in the drivers door that break in the loom

then itis the power switch in the door/ Please rate my response thank you very much

Cable must of disconnected need to take door cover off and reconnect...

try replacing the master switch it maybe malfunctioning due to wear.or may have shorted out by getting wet or something.since it is the primary control for all windows and power door locks.