This mirror control switch will pop right out with just a thin blade type screw driver. Slide the blade of the screw driver under the edge of the switch carefully and twist slowly until you can see the switch coming up. You may need to re position the switch as there is a bit of play in the hole the switch fits into to. Once you have the switch up and out of the panel, carefully release the wires it is clipped to and replace it with one that is good. It is a typical sign these witches have gone bad if your mirror only moves in 2 directions or both mirrors are moving at the same time. I hope I have helped you with your problem.
SOURCE: I need wiring diagram for a 1999 Ford f250 side
make your self a jumper set of wires to test with. Find out what makes what move on the old unit,write down the color wire,then apply power and ground to the new unit onw wire at a time.Mark down the color and what function it did.after testing both units then match your research and put the wires together.I wished I were there.Good Luck!
SOURCE: need to replace F250 passengers side mirror.
take the door panel off there is 2 to 3 bolts holding it on
SOURCE: replace driver side power mirror on 2003 ford crew...
Muth makes the signal mirrors for repalcing the glass in the mirror head. On the site, they have nice instructions you can use for removing the door panel, and getting the mirror off ( obviously stop at the removing the glass part, and just replace with the mirror head you already have ).
Enter the Make, MY, and model you have, and on the products page are the links to the PDF version of the instructions for download.
www.kwmuth.com
SOURCE: how do i remove the wing mirror (power adjust
Roll the window down first, you will need 2 hands. Pull the small cover off that is at the top front of the door pannel. You will then disconnect the wire connector and remove the three 11mm nuts that are holding the mirror in place. Pull mirror out and replace.
If you dont have just that little pannel you will have to remove the door pannel. If you dont have power windows pull the cover out on the window crank and move it to the side, there will be a screw holding the crank in place. Remove it. If you do have power windows remove the window control switch plate (it will just pop up using a small screwdriver) and disconnect the wires. If equipped, remove the front door trim panel reflector or the courtesy lamp lens. Then remove the screws. DO NOT pull directly outward on the door pannel, something will brake. Remove the front door trim panel by pulling it straight upward.Lift and remove the front door trim panel. Then the nuts holding the mirror will be visible, remove and replace the mirror.
SOURCE: 2002 Ford F250 Super Duty SuperCab l/h power mirror intsallation
http://rogerweber.blogspot.com/2006/09/replacing-ford-f-250-super-duty-side.html try this website its step by step instructions and illustrations. hope this helps
1,144 views
Usually answered in minutes!
×