Subaru legacy hazard lights won't turn off - 1995 Subaru Legacy

SOURCE: a/t light is flashing 16 times n 1995 subaru legacy

if by a/t you mean automatic transmission try a power purge transmission service it may have a filter sensor that is telling you to service soon

SOURCE: Can't find the hazard flasher for '93 Subaru Legacy!

they are usually one and the same box fuse...you might try putting in a new one

SOURCE: My 1999 subaru parking lights will not turn off

the rocker switch on top of your steering column is on.

SOURCE: '97 subaru legacy L,AWD wagon, 2.2L, auto trans.

Do you hear a 'click' when the key is turned to start? Have someone try the key while you listen under the hood. It should be the starter solenoid clicking. You need either a test light or voltmeter to test further. One large terminal on the solenoid has the large wire from the battery positive, and should always show voltage/light at all times. Test the other side of the solenoid (large terminal) that is connected to the terminal on the starter motor. It should show light/voltage when the key is turned. If it doesn't, the solenoid must be replaced. If it does show light/voltage, then the starter motor is defective (probably brushes). If you get no click when turning the key, test the small terminal on the solenoid, you should see a voltage/light change when the key is turned. If you see a change, but no click, the solenoid coil is open or the case of the solenoid is not grounding where it is mounted. Try loosening the mounting and re-tighten. If no help, replace the solenoid. If you see no change at the small terminal, remove the wire from it and using a spare piece of wire, touch the small terminal to, first, the large terminal that the battery is connected to, then to the the mounting bolt for the solenoid. If the solenoid is good, the starter should operate with one of these two tests. In that case, the starter position of key switch is open--replace the ignition switch.

SOURCE: 1995 subaru legacy l the dashboard lights are not working

• Check fuse #9 at in car fuse panel
• Check Illumination CTRL Module for melt-down
• Check that Tail and Illumination relay is fully seated, top center of in-car fuse panel.