P2106 engine light on and engine have same speed you cant acceleration engine

code p2282 is a vacuum leak. because of it your PCM is going into LIMP HOME MODE. Check for a broken hose or intake manifold gasket leaking

Faulty Accelerator Position Sensor(APS)
- Faulty APS+Brake
- Faulty APS + Vehicle speed sensor
- Faulty APS + Vehicle speed sensor + Brake
- Faulty Electronic Throttle Control(ETC) Items(TPS or ETC motor etc)
- Faulty Powertrain Control Module (PCM)

I suggest check the easy things first. Vacuum lines, could cause a lean condition, fuel filter restricting the fuel flow lean condition. Carefully clean throttle body with proper cleaner. I'm a shade tree mechanic but these simple things work sometimes. You didn't mention if you have the cvt trans. If you do and you are going 75 80 on the highway coming to a hill will cause it to race that high. Then when the hill is crested it will slow down, I don't like it either but it is the nature of the beast. I often cancel the cruise on big hills on the highway so it doesn't do that.

Here is what meens those codes:

P2106
Throttle Actuator Control System - Forced Limited Power

P2110
Throttle Actuator Control System - Forced Limited RPM

P2135
Throttle/Pedal Position Sensor/Switch "A"/"B" Voltage Correlation

P1516
Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

I beleive that there is, specifically for chevrolet aveo 2006 a technician service bulletins.

You should have it checked at gm dealer!!!

ask for
TSB Number: SB-08-06-04-004
TSB Number: 08-06-04-023

is it the ecotec engine fitted 1.8 or 2.0./2.2l or the diesel 1.7 engine.. how long have you not used the air con for. not using it for a long time you can damage the pump the flown sensor. even the temperature sensor. but if the engine is trying to stall with the ac on then the pump may have a fault. ac should be run for 10min once a week no matter the weather. stops you having problems later.

p0720 is the output shaft speed sensor for the transmission. If the sensor isn't faulty you need to check the wiring for opens and shorts. If that checks out than I think your transmission is not good. the p2106 is a limp mode code. Correct me if I am wrong anyone. this post is six years old so I am sure they found the answer and I would like to know if I am correct.

These codes indicate your accelerator position sensor has malfunctioned. The computer has gone into limp mode, which allows you to drive to safety without damaging the engine. The computer is unable to determine how far you are depressing the accelerator and doesn't want to over-rev the engine. You need a new sensor.

TSB # 08-FL-004-1 CHECK ENGINE LIGHT P2135 DTC DIAGNOSIS....
there is a problem with the pedal assembly which has your throttle position sensor causing the codes, dealer only part you can install yourself with some know how