SOURCE: trying to remove glove box
Regards,
Tony
SOURCE: 97 Jeep Grand Cherokee lights won't work high
Use a test light, or a ohmmeter and check the wires at the wire plug under the dash that go to the multi-function switch thru the steering column cover, you should have continuity between #18 and #19 low beam terminals, if not the switch is bad and will need replaced. it shows how to check this in Haynes 1993 to 2004 Jeep Grand Cherokee repair manual #50025 page 12-6. To replace the switch in the column cover, remove the negative battery cable, wait 2 minutes to disarm the air bag system, leave cable disconnected, before removing the column cover.
SOURCE: 1995 grand jeep cherokee won't take freon why
You do know the compressor must be running to allow the system to be charged, right ?
If the system is low you have to jumper the low pressure switch or otherwise provide power to the compressor to put new cans of freon in.
And it will only go in on the low side of the system, which should be the only side you can connect the hose to.
SOURCE: 2002 jeep grand Cherokee change batt. Now it starts but won't run?
Because you disconnected the battery you lost the long trim value,you will now have to relearn the idle,start the vehicle idle it to 1500 RPM,hold for a minute,idle should stabilize,turn on A/C let it idle,for a minute,now your done,
SOURCE: 1997 Jeep Grand Cherokee won't accelerate past 40 mph
throdle position sending unit is broken, or throdle cable is warn out.replace both,should fix
399 views
Usually answered in minutes!
×