No, the dme is coded by vin, the car would not start if you tried to program, you could perhaps snag the ews and lcm from the same car you got the dme from. But the. You might have a issue with the new lcm trying to update mileage to the old Komi. A lot less headaches to just order one coded from BMW why do you think it needs a dme?
SOURCE: need a cheap place to install a new locking device in my BMW X3
bmw can reprogram to computer code that is used to start the car, you don't need to change keys, just the computer code. Bmw place can do this...
SOURCE: bmw x3 2.0d 05 will not start in cold weather, had
Try to check the Fuel fump relay, sometimes the contact is burn out and cause of hard starting. it is located at the back of junction box. you have to remove Glovebox to access it.
SOURCE: how long does it take to install a fuel pump for a
If qualified and/or experienced, then 30-70mins
SOURCE: 05 bmw x3 no start
If everything else checks out, I would look at the anti theft system. Your car has a factory installed anti theft system that also includes an ignition kill. I would have the system checked. Check your owners manual, there might be a chapter in it concerning the theft system.
SOURCE: How to program a previously used BMW keyless
1) Get in and close all doors.
2) Turn on the ingition and turn off quickly. (No more than 5 seconds) to start the process. Next action must take place within 30 seconds.
3) Remove the 1st key.
4) Hold the key up near your left shoulder (this is so it is closer to the remote reciever antenna - someone else suggested this).
5) Hold down the unlock button (which is button 1 on my key) and press the lock button 3 times (center button on my key). Release the unlock button and the doors lock which confirms the operation.
6) Quickly repeat steps 4 & 5 for key #2 etc.
If it does not work, try doing the keys in opposite order. Key 2 then key1, vs 1 then 2
288 views
Usually answered in minutes!
×