What does this mean p0141 for2001 nissan sentra

Hi Joe
Don't forget it is P-Zero and not P-Letter O.

Yes, just about. This is the one that will leave you stranded though.

P0354 OBD-II Trouble Code: Ignition Coil D Primary / ...

YourMechanic https://www.yourmechanic.com > Articles
Trouble code P0354 means there's a problem in ignition coil D circuit, probably an electrical problem, and the engine will run rough or stall.

Nissan; MIL ON with DTC P0101

National Highway Traffic Safety Administration (.gov) https://static.nhtsa.gov > odi > tsbs PDF Dec 1, 2016 - The MIL is ON with DTC P0101 for Mass Air Flow sensor (MAF) stored in the ECM. ... 2011 Sentra. (with MR20DE engine). 9AA0A, 9AA1A, 9AA2A, 9AA3A.
11 pages

Code P0101 2011 Nissan Sentra Mass Air Flow Circuit ...

AutoCodes https://www.autocodes.com > p0101_2011_nissan_sen...
The Mass Air Flow (MAF) sensor is placed in the stream of the intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It ...

..

https://www.modifiedlife.com/2006-nissan-sentra-car-stereo-wiring-guide/

standing in front of the vehicle looking at the engine bank 1 sensor 2 is the sensor after the cat converter on the bank on your left
bank one is the left cat ---bank 2 is the right cat. Sensor 1 is the one before the cat and sensor 2 is the one after the cat on either side

p0325 = bank 1 sensor 2 oxygen sensor p0141 = knock sensor
if it were me you could watch the sensor on a scanner to see if working properly but without a scanner i'd replace the oxygen sensor bank 1 = passenger side
sensor 2 is sensor behind the catalictic converter screwed in

good luck

the trouble code P0141 stands for Oxygen O2 Sensor Heater Circuit Malfunction (Bank1, Sensor2).

Check with a multimeter if the heater circuit of the second lambda sensor has a resistance value or if it's in open circuit. If it is in open circuit the lambda sensor is damaged. Replace it.

The car shaking ca be caused by a gearbox problem or a misfire in the engine. Check the spark plugs and the ignition coils.

The MAF sensor can have 5 or 4 wires coming out of the connector. It depends if it has a air temperature sensor or not.

Hope i helped you.

The blinking light doesnt mean that u have a security system it means that Nissan immobilization system (not an security alarm system) is working, which i believes comes standard on all new nissan cars now. but this feature prevents someone starting the car without a nissan key, because our keys have a microchip in it which the car can read. and if a key that doesn't have the right chip in it is used it wont turn on.

Check in your owners manual the right disarm procedure.

p0136 and p0141 are o2 sensors and p0401 is a egr flow and the p0171 means its running lean on low bank 1

check your radiator if theres a bubbles while your engine runnin, if theres bubble, it means you overheat. check your cylinder head for warps... also check your fans...

Main shaft part number should be 32241-U13U004. Not sure what you mean when you say cluster shaft bearing.

do you mean the speedometer or the engine RPM ----gearbox??? if its the engine RPM their is no sensor as it reads from the ECU unit which is controling the engine management